Dynavet Effitek Instrukcje użytkowania - Strona 4
Przeglądaj online lub pobierz pdf Instrukcje użytkowania dla Produkt do pielęgnacji zwierząt domowych Dynavet Effitek. Dynavet Effitek 5 stron. Anti-bark collar
Drukuj stronęThe collar automatically adjusts the level of electrostatic stimulus
according to the dog's sensitivity and the frequency of its barking.
Use
This mode is recommended in the dog's education phase or for regular
use.
For best results, be around during the first trials long enough to observe
your dog and monitor its progress. Check the electrodes are making good
contact on the dog's skin.
Mode 2: Audible stimuli only
Operating principle
Each time the dog barks, a warning is given in the form of a "beep".
Use
This mode is recommended for dogs already educated in the collar.
A simple audible stimulus is sufficient to stop the barking.
Mode 3: Electrostatic stimuli only with gradual increase from level 1 to
level 8
Operating principle
The mode 3 operation is the same as that for mode 1 but with no beep
given off before the electrostatic stimulus.
Use
This mode is used for dogs having difficulty associating the beep and
the electrostatic stimuli.
MODES
STIMULI
AVAILABLE
Audible beep + elec-
Mode 1
trostatic stimulus with
(factory
increase in the intensity
set mode)
of the stimulus if the
barking continues
Mode 2
Audible beep only
Mode 3
Electrostatic stimulus
only with increase in the
intensity of the stimulus
if the barking continues
4.2 - Operating mode selection
The collar is set by default to mode 1.
Change the mode by passing the magnet over the green point (magnetic
contact).
The mode is selected by holding the disc/magnet over the green point
(magnetic contact): the LED flashes.
Care: hold the disc/magnet over the green point for at least 3 seconds
for proper recognition.
Keep the disc/magnet there until you hear the number of beeps relating
to the mode required:
MODES
AVAILABLE
Mode 1
Emission of 1 beep + 1 LED flash
Mode 2
Emission of 2 beeps + 2 LED flashes
Mode 3
Emission of 3 beeps + 3 LED flashes
USE
For the learning phases.
The beep serves to warn the dog of
the electrostatic stimulus.
The dog gradually associates the
beep and the electrostatic stimulus.
For dogs educated with mode 1,
the beep alone is sufficient to
stop the barking.
For dogs educated in Mode 1 but
which continue to bark in Mode 2.
SELECTION
Anti-bark collar instructions for use - 3/4