adeptus Jennifer 78113 Instrukcja montażu - Strona 11
Przeglądaj online lub pobierz pdf Instrukcja montażu dla Wyposażenie wnętrz adeptus Jennifer 78113. adeptus Jennifer 78113 12 stron. End table
Drukuj stronęATTACH THE RIGHT AND
12
LEFT DRAWER RUNNERS.
TIP: To make this step easier, place the drawer
upside down on a counter with the drawer front
hanging off the edge. This will allow the drawer
box to lay flat and provide better control for
tightening the screws. DO NOT OVER-TIGHTEN!
ENSURE THE
WHEEL IS TOWARDS
THE BACK AND THE
RUNNER IS PUSHED
COMPLETELY
FORWARD,
TOUCHING THE
DRAWER FRONT.
F=06
G=01
3,0 x 16mm
INSERT THE DRAWER
13
Tilt the back of the drawer upward to get it past
the wheels on the drawer runners.
Once clear of the wheels, you can level the
drawer and slide it in.
Complete these steps for both the left and the right side of the drawer.
NOTICE:
F
F
H=01
GA
HA
HB
GB
Left Set Right Set
• Loosen the screw (part F) you used to
install the drawer runner to the side panel
(parts 02 or 03), depending on the side
(left or right), as shown.
• With the screw (part F) loosened, you can
make the necessary slight adjustments (up
or down) to the drawer runner to achieve
the proper drawer front alignment.
F
ENSURE THE SCREWS ARE INSERTED
THROUGH THE CORRECT HOLES IN
THE RUNNER. SEE THE ENLARGED
F
DIAGRAM ABOVE.
F
F
CONTAINED
F
F
Gb
After completed assembly, it is
necessary to adjust the drawer
alignment to get the drawer
perfectly square.
Once the drawer
alignment is square,
secure the position of the
drawer runners to the side
panels by re-tightening
the part F screw.
F
Hb
F=02
3,0 x 16mm
11-12