DDM DDMMSE Instrukcja obsługi - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Piła DDM DDMMSE. DDM DDMMSE 17 stron. Brick saw masonry saw series

GENERAL CUTTING GUIDELINES

� ��

RIP CUTTING

diagonal

square cut

TABLE MARKINGS

��

ADJUSTING THE CUTTING HEAD

��

BELT ADJUSTMENT AND REPLACEMENT

The DDMMS Saws utilize a premium oil & heat treated V-belt the is tensioned at the factory. The belt may require a slight

adjustment after it "breaks-in" and seats on the pulleys (usually after several months of usage). Additionally, after heavy

usage over time, the belt may become worn, frayed or cracked. For retension or replacement of your V-belt, loosen the (4)

nuts that secure the motor base to the cutting head, remove the belt guard casting, loosen the motor strap bolt, replace/

reseat the V-belt, tightening the motor strap bolt (provide @ 1/2" pinch/deflection from the center of the V-belt), replace the

belt guard casting, tighten the (4) motor plate screws & resume operations.

��

BLADE SHAFT ASSEMBLY

The �� utilizes a unique maintenance-free blade shaft bearing assembly. The aluminum casting

supports (2) double sealed bearings, a heavy-duty blade shaft and an inner and outer blade flange. The

bearings are permanently lubricated, totally enclosed, and are self-aligning. Over a period of time and

usage, the shaft may begin to make excessive noise and vibrations, signaling the necessity for component

replacements. The maintenance is easily accomplished by replacing this (1) piece assembly in its entirety.

The assembly is removed and replaced by (4) bolts, is self-aligning, and is immediately ready for work.

��

WARNI NG

��