Gallien-Krueger 2001RBP Instrukcja obsługi - Strona 15
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wzmacniacz Gallien-Krueger 2001RBP. Gallien-Krueger 2001RBP 20 stron. Bass amp and preamp
Również dla Gallien-Krueger 2001RBP: Instrukcja obsługi (20 strony)
Drukuj stronę
Rear Panel Controls
1 . A C R e c e p t a c l e :
The power cord is detachable and plugs in here.
2 . R e m o t e T r i g g e r :
This feature is used when using multiple 2001RB's as
"master" and "slave" units. It allows you to turn on
all amplifiers at the same time, when the "master"
unit is powered on.
I n :
Accepts the +12VDC signal from the "master"
2001RB's Trigger Out jack to activate or turn on, the
"slave" 2001RBs when in standby mode.
O u t :
Provides +12VDC as a trigger output to remotely turn
on a "slave" 2001RB.
3 . R i g h t " S p e a k o n " O u t p u t s :
Enables BI-AMP operation by connecting a GK-RBH
Series cabinet with the provided 4 conductor Speakon
cable. This connects the 50W amplifier allowing the
Tweeter control on the front panel to control the
signal going to the horn. See Bi-Amp and Normal
Operation on page 7 for more information.
4 . R i g h t S p e a k e r O u t :
540W power amp output for Full-Range operation
only. They deliver 540 watts into 2 Ohms or 360 watts
into 4 Ohms. Lower impedances should not be used.
5 . R i g h t L e v e l :
This adjusts the output level of the right channel only
in dual-mono mode.
6 . B r i d g e M o d e :
This allows one to switch from Dual/Mono to Bridge
mode.
2001RB & 2001RBP
7 . L e f t S p e a k e r O u t :
540W power amp output for Full-Range operation
only. They deliver 540 watts into 2 Ohms or 360watts
into 4 Ohms. Lower impedances should not be used.
8 .
L e f t / B r i d g e d
Enables BI-AMP operation by connecting a GK-RBH
Series cabinet with the provided 4 conductor Speakon
cable. This connects the 50W amplifier allowing the
Tweeter control on the front panel to control the
signal going to the horn. See Bi-Amp and Normal
Operation on page 7 for more information.
These "Speakon" outputs also enable "bridged
mode" operation. When in bridged mode, the 2001RB
will be in a simultaneous bridged/Bi-amp mode, since
the 50W horn amplifiers are always active ( in the
clean channel only) unless you choose to use the
"horn mute" feature, via the RFB-III footswitch.
DO NOT CONNECT ANYTHING TO THE RIGHT
CHANNEL OUTPUTS WHEN IN BRIDGED MODE!!
DO NOT USE "BRIDGE MODE" CABLES WITH THIS
AMPLIFIER, AS THIS COULD RESULT IN A
MALFUNCTION AND/OR DAMAGE TO THE
AMPLIFIER.
9 .
F o o t s w i t c h :
Provides a means to hook-up the RFB-III, three
button footswitch to your amplifier, with a standard 5
pin DIN (MIDI) cable. The RFB-III allows remote
Channel Switching (Level A or Level B), Horn Mute
(when in the clean channel) and Tuning Mute.
15
" S p e a k o n "
O u t p u t s :