Gallien-Krueger Legacy 800 Instrukcja obsługi - Strona 5
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wzmacniacz Gallien-Krueger Legacy 800. Gallien-Krueger Legacy 800 10 stron.
Drukuj stronę
Safety Information
Please read all enclosed safety precautions
before connecting or operating this product.
Verify Line Voltage and Amperage: Your
amplifier has been factory configured to use
with the line voltage 100-240Vac 50/60 Hz.
100-120 Volt/60Hz 15A circuit for USA
and Canada.
220-240 Volt/(50/60Hz) 10A circuit for
UK and Australia.
220-240 Volt/(50/60Hz) 10A circuit for
Europe.
100-120 Volt/50Hz 15A circuit for Japan.
220-240 Volt/50Hz 10A circuit for Korea.
Proper AC circuit for all other countries.
Connecting the amplifier to a line with
specifications other than indicated above can
create safety and fire hazard, and may
damage the amplifier. If you have any
questions about the voltage requirements
for your specific model, or about the line
voltage in your area, contact your dealer
before plugging the unit into a wall outlet.
Verify AC Circuit Capacity Before Use:
The high power output of your amplifier
may require heavy current draw under
full-load conditions. To insure proper
performance and avoid potential safety
hazards, we recommend connection to line
circuits with amperage
above". Connecting to the same circuit
used by other heavy power devices, such
as high wattage lights, may cause circuit
breakers to trip. It is always a good idea to
avoid using any audio equipment on the same
AC circuit as equipment with motors, such as
air conditioners or refrigerators. This will
lessen the possibility of power variation and
electrical start-up noise affecting your sound.
Please refer to page 9 for more
instructions concerning installation.
AC Power Cord: To avoid safety hazards,
use only the power cord supplied with your
unit. If a replacement cord is needed, make
certain to use a standard IEC compliant
cord. Damaged power cords should be
replaced immediately. When setting up,
make certain that the AC plug is easily
LEGACY SERIES
accessible. If you do not intend to use the
amplifier for a considerable length of time,
disconnect the plug from the AC mains
socket. Do not use an extension cord.
Earth Grounding Connection: To prevent
electric shock, do not remove the grounding
plug on the power cord, or use any plug or
extension cord that does not have
grounding plug provided. Make certain that
the AC outlet is properly grounded as well.
Do not use an adapter plug with this
product.
Do Not Open the Amplifier Enclosure:
There are no user serviceable parts inside
this
enclosure may present a shock hazard.
Modification to the product will void your
warranty. If liquid enters the unit, or any
metal object such as a paper clip
accidentally falls inside the enclosure,
disconnect the unit from the AC power
source
authorized service station.
Setup: To insure proper operation and to
avoid potential safety hazards, place the unit
on a firm, level surface. Do not plug or
unplug the instrument or speaker cable
while the amplifier power is on.
Heat & Ventilation: Make sure there is
space provided for proper ventilation.
Avoid using in extremely hot or cold
locations and areas that are exposed to
direct sunlight or near heating equipment.
specified
"as
Avoid using in moist or high humidity areas.
USA: Indoor use only.
Norway: Apparatet må tilkoples jordet stikkontakt
Sweden: Apparaten skall anslutas till jordat uttag
Finland: Laite on liitettävä suojakoskettimilla varustettuun
pistorasiaan
Denmark: "Apparatets stikprop skal tilsluttes en stikkontakt
med jord, som giver forbindelse til stikproppens jord."
China: 在海拔高度 2000 米或更低和非热带位置仅用
5
product.
Opening
immediately
10cm or 3.94"
rear
LEGACY SERIES
required clearances
10cm
front
3.94"
1.27cm OR 0.50"
TOP CLEARANCE
NEVER BLOCK THE FAN VENT
HOLES ON THE SIDES OF THE UNIT!
a
the
amplifier
and
consult
an
10cm
3.94"