Agrowtek SXW Instrukcja obsługi - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Rejestratory danych Agrowtek SXW. Agrowtek SXW 11 stron. Weather station sensor & data logger

Drukuj stronę

Assemble Mounting Bracket

Optional stainless steel pole mounting bracket allows all weather station components to be mounted on a

single pole for simple installation. It is recommended to mount the base of the pole on a hinge point so that

the sensor array can be tipped down to ground elevation for service without a ladder.

Install Wind Sensors

1. Insert direction vane and anemometer brackets

into slots located in the top of the bracket (2).

2. Using the provided screw and nut kit, fasten the

wind sensors to the bracket through the holes in

the brackets.

3. Route wires through the grommet in the top of

the mounting bracket.

Install SXW Sensor

1. Remove the top cover from the SXW sensor and

locate the 7/8" diameter hole in the bottom of the

enclosure.

2. Assemble the stand-o pipe (1) through the

hole and secure with included EMT nut (2).

Note: hand tighten nut, then turn pipe to tighten.

Note: circuit board may be removed temorarily to

increase access to the nut if required.

3. Install pipe and sensor assembly into bracket

mounting hole (3) and secure with EMT nut.

4. Route RJ-45 cable from sensor circuit board

through stand-o pipe.

5. Route wind sensor cables into sensor through

stand-o pipe (1). Keep cables under protective

cover (4) area to shield from sun and rain.

Mount on Pole

1-3/8" diameter clamps for 1" conduit or PVC pipe clamps secure with nuts on the back side of the bracket.

Route the RJ-45 GrowNET™ cable through the pole to shield it from weather.