CORA CS1000 Podręcznik użytkownika - Strona 7
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Akcesoria CORA CS1000. CORA CS1000 17 stron.
Drukuj stronę
Installation
1.
The sensor and magnet are very difficult to relocate after being affixed to the mounting
surface. Test the sensor and magnet location before affixing the device to the surface.
Use masking or painter's tape to secure the sensor and magnet to the surface (align the
semi-circle on magnet with the semi-circle on sensor). Once the sensor and magnet
temporarily are mounted, test it to ensure that generates open and closed alarms .
2.
Be sure the installation gap between the sensor and magnet is within 0.4 inch and the
semi-circle on the magnet is aligned with the semi-circle on the sensor body when
closed.
3.
Avoid exposing the sensor to strong impacts of vibration. The sensor body should be
mounted on the fixed part (frame) of a door or window, while the magnet should be
mounted to the movable part of the door or window.
4.
The sensor operates with a magnetic reed-type switch. Take care to install away from
other strong magnetic fields or spurious alarms could occur.
Attaching the Door Sensor and Magnet
1.
Clean the Installation Area:
2.
Remove the protective layer from the rear of sensor
and place it in the desired position (fixed part of door or
window) and press firmly for at least 5 seconds.
3.
Remove protective layer from rear of magnet and align
the magnet semi-circle with the body semicircle, press
firmly for at least 5 seconds.
CS1000 Long Range Door Sensor – User Guide
Page 7