CORA CS1010-CL-US9HT-00 Podręcznik użytkownika - Strona 4
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Akcesoria CORA CS1010-CL-US9HT-00. CORA CS1010-CL-US9HT-00 15 stron. Long range leak sensor
Drukuj stronę
CS1010 Long Range Leak Sensor – User Guide
Attaching to the Network
Once the device is removed from the packaging, it can be activated by pressing the set button.
The device will activate, blinking orange four times and begin issuing join requests. The LED
status indicators is shown in the figure below.
Figure 2 – CS1010 LED Status Indicators
Periodically, the CS1010 will blink red twice when joining the network. Assuming the device is
properly registered on an available network and in range, it should connect. It will blink green
four times indicating it has joined.
Once joined, the leak sensor can be tested by placing the device in a wet dish or touching the
top sensors with a wet finger. By default, the unit will generate leak detect and clear events to
notify the application. Reminders and other configurations options are available.
Note: If the CS1010 has not joined within a few minutes, the LED will stop blinking, though it will
continue try to join: ten times in the first hour, then longer intervals over the first week until finally
attempting once every 12 hours. This is done to conserve battery power when the network is not
available for long periods of time. You may reset the join schedule by performing a Network
Reset on the device, see User Interface.
To learn more about the capabilities of the CS1010, see Configuration and Integration.
User
Interface
Set Button
The CS1010 user interface consists of the LED status indicators (Figure 2) and the set button
located on the underside of the device. Pressing the button quickly will indicate the current
network status discussed previously.
Page 4