CORA E3VR Instrukcje montażu i instalacji
Przeglądaj online lub pobierz pdf Instrukcje montażu i instalacji dla Stojaki i stojaki CORA E3VR. CORA E3VR 2 stron. Bike rack
Drukuj stronęAssembly & Wall Mounting Instructions
Cora Bike Rack - E3VR/ E3VR-F
Washer to go
under screws
X3
Wall plugs
X3
Rack X1
(E3VR or E3VR-F)
2. Mounting height of single or multiple adjacent racks (E3VR or E3VR-F)
For Single mounted rack
If mounting only one rack,
the rack should be fixed in
lower position to minimise
lifting for cyclist
3. Drill mounting holes in wall
Drill three (3) holes at
correct hole centres. Use
dimensions in image for hole
location
Drill holes 10mm diameter
and min 40mm depth to
accept wall plug for M8
screw
Cora Bike Rack - Australia's Bike Parking Experts - WWW.CORA.COM.AU - PH 1800 249 878
1. If mounting multiple racks, measure mounting distance between
racks and other obstructions and height from ground
M8 Security
Screws for
Rack mounting
X3
Security screws
tool bit X1
35mm
For Multiple mounted racks
If multiple racks are
being mounted next to
each other, Rack height
must be alternated
NOTE: If all racks are to
be mounted at the same
height, racks must be
spaced at 700mm
centres
4. Insert wall plugs
min.500mm
spacing between
racks or from walls
To
comply
with AS2890.3
(2015) minimum 500mm
spacing between posts
centres and to edge of
walls or other
obstructions
OR minimum 400mm
spacing between posts
centres and to edge of
walls or other
obstructions
(this will not
comply to AS2890.3)
Rev 3.00 Sept 2016 ©