Galvin Engineering CliniMix WM-PMSKIT Instrukcja instalacji produktu - Strona 6
Przeglądaj online lub pobierz pdf Instrukcja instalacji produktu dla Produkt hydrauliczny Galvin Engineering CliniMix WM-PMSKIT. Galvin Engineering CliniMix WM-PMSKIT 6 stron. Inwall shower disinfection kit
Drukuj stronę
TROUBLE SHOOTING
PROBLEM
Cold water handle is turned on
instead of hot.
Cold instead of hot
water flowing
The disinfection unit has been
installed incorrectly.
The disinfection unit has been
installed incorrectly.
Cold or hot handle not turned on
Water not flowing
fully.
No mains water.
WARRANTY
The warranty set forth herein is given expressly and is the only warranty given by the Galvin Engineering Pty Ltd.
With respect to the product, Galvin Engineering Pty Ltd makes no other warranties, express or implied. Galvin
Engineering Pty. Ltd. hereby specifically disclaims all other warranties, express or implied, including but not limited
to the implied warranties of merchantability and fitness for a particular purpose.
Galvin Engineering Pty Ltd products are covered under our manufacturer's warranty available for download from
www.galvinengineering.com.au Galvin Engineering Pty Ltd expressly warrants that the product is free from
operational defects in workmanship and materials for the warranty period as shown on the schedule in the
manufacturer's warranty. During the warranty period, Galvin Engineering will replace or repair any defective
products manufactured by Galvin Engineering without charge, so long as the terms of the Manufacturer's warranty
are complied with.
The remedy described in the first paragraph of this warranty shall constitute the sole and exclusive remedy for
breach of warranty, and Galvin Engineering Pty Ltd shall not be responsible for any incidental, special or
consequential damages, including without limitation, lost profits or the cost of repairing or replacing other property
which is damaged if this product does not work properly, other costs resulting from labour charges, delays,
vandalism, negligence, fouling caused by foreign material, damage from adverse water conditions, chemical,
electrical or any other circumstances over which Galvin Engineering has no control. This warranty shall be
invalidated by any abuse, misuse, misapplication, improper installation or improper maintenance or alteration of
the product.
CAUSE
Version 1, 22 October 2019, Page 6 of 6
RECTIFICATION
Ensure the hot handle has been fully turned
clockwise and the cold is fully turned off.
Follow installation steps 3 – 9 and ensure the
unit has been installed correctly.
Follow installation steps 3 – 9 and ensure the unit
has been installed correctly.
Ensure the relevant handle is turned fully
clockwise.
Contact your maintenance manager.