Coralife T5 Instrukcja obsługi - Strona 2

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Oprawa oświetleniowa Coralife T5. Coralife T5 4 stron. High output aquarium light fixture

Drukuj stronę

IMPORTANT SAFETY NOTE

Always turn off light fixture and unplug power cord from

outlet before adjusting fixture position over aquarium or

when replacing any parts on the fixture.

CAUTION:

. Light fixture is for use over covered aquariums only.

2. Light fixture is for indoor household use only.

3. Do not allow light fixture to come into direct contact

with water.

4. Light fixture must be plugged into a receptacle controlled

by a GFCI (ground fault circuit interrupter) circuit breaker

and must be properly connected to a grounded three-

prong receptacle (fig.1).

Specifications for Coralife High Output T5

Dual Strip Light

SIZE

VOLTAGE

24"

120V

60 Hz

30"

120V

60 Hz

36"

120V

60 Hz

48"

120V

60 Hz

Installation Instructions

1. Remove end cap and acrylic lens

from end of fixture by removing the

two retaining screws with a cross

head screwdriver. Remove foam

insert from bulbs (fig. 2).

2. Starting with the leg destined for the

opposite end of the fixture, slide the

legs into the two grooves located on

the front and back of the fixture.

After both legs are inserted replace

the acrylic lens retainer. Legs should

curve outward away from the end of

the fixture.

3. Adjust legs left or right so that fixture sits evenly and securely

over top of aquarium.

4. Plug light fixture into an acceptable outlet. Be sure to

incorporate a "drip loop" to prevent water droplets from

running down the cord and into the outlet should any water

get onto the cord (fig. 3).

WATTS

10,000K HO T5

48 watts

62 watts

78 watts

108 watts

LAMP #1

LAMP #2

ACTINIC HO T5

24 watt

31 watt

39 watt

54 watt

fig. 1 - Three-Prong

Receptacle