KitchenAid 2000495 Instrukcja instalacji - Strona 6
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Lodówka KitchenAid 2000495. KitchenAid 2000495 12 stron. 42” built-in refrigerator
Drukuj stronę
-.
Product dimensions
+/- I/W tolerance
protruding
door
inslallalion
23-7/&T' depth
flush door
inslallalion
spacers
1.
Attach three spacers from the
miscellaneous
parts bag to the
top, middle and bottom of each
side of the refrigerator.
Spacers
are required for ventilation.
-
42" -
side panel
support
nailer
b
I
25"
2. A side panel support nailer
should be attached to the rear
3. If less than 25" depth is
wall on each side of refrigerator
available, side panel
installation
will need to be
Page 6
doors
side trim
Refrigerator
when 25" depth is available. If
less than 25" depth is available,
go to step 3.
If side panel is not inserted into
side trim, drill six equally-spaced
holes in each side trim as
shown.
Do Not drill into side
of cabinet.
Attach side panels
to side trim using six screws on
each side.
Side panel thickness should be
l/2" minimum to prevent
"blousing" or warping.
side panel
support
nailer
112" side panel
recommended
c-spacer
-2
-side
trim
5/32"+
+-
l/4"
19132"
4
--t,,,,"
1
Side trim
completed according to each
site's restrictions.
One method is to attach side
panel to outside of side trim.
However, this will increase
width required.
Drill holes into
side trim. Attach a wood.suppon
to side trim. Attach side panel
to panel support nailer and
wood support.
Cover wood
support with a panel piece to
match side panel.
notches
for
door hinges
toe panel
recess ,/
-I
4. Height of side panels depends
on your installation
site. Side
panels may need to be notched
to clear door hinges. Side
panels may be cut to match toe
panel recess if desired.
Notch side panel only after
the installed height of the
refrigerator has been
determined.