Gama Sonic GS-113P Instrukcja obsługi - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Oświetlenie zewnętrzne Gama Sonic GS-113P. Gama Sonic GS-113P 4 stron. Flora solar lamp

Installation Instructions

GS-113F

NOTE: If you are replacing an existing gas or electric light, you must consult a

certified technician to disconnect the gas or electricity before installation of solar

lamp.

Place solar lamp on top of your existing 3" post and tighten the 3 screws

provided to secure the lamp.

GS-113P

Using the anchors screws, if needed,

1. Use electric drill to make two holes in the desired surface that match

the holes on the solar lamp base.

2. Place the provided screw anchors into holes.

3. Place the lamp base in line with the holes and screw the base onto your

desired surface with the provided screws.

GS-113W

NOTE: locate your solar lamp facing the south for best results.

Using the screw anchors, if needed:

1. Remove wall lamp support piece by unscrewing the bronze screw caps

from the back of the wall unit.

2. Use electric drill to make two holes in the desired location which

match the holes on the lamp support piece, and place provided anchors

into holes.

3. Place the wall lamp support piece in line with the holes and screw in

using the provided screws.

4. Attach solar lamp to wall support piece and secure with bronze screw

caps.

Replacing the Batteries

(After several years of use, the battery may need replacing).

1. Unscrew the two screws and detach part (A) from part (B). Make sure

the ON/OFF switch (Fig. 1) is in the OFF position.

2. Unscrew the battery compartment screw located on the silver reflector

and remove the battery compartment door.

3. Unclip the connector and remove the old battery. Make sure the new

battery is high quality 3.2V/1,500mAh Li

with connector.

4. Clip on new battery and install into the battery compartment. Screw

back battery compartment door.

5. Reattach part (A) to part (B) and secure with the 2 screws.

-ion

Rechargeable battery