Dynon Avionics SkyView Instrukcja strojenia - Strona 8
Przeglądaj online lub pobierz pdf Instrukcja strojenia dla System autopilota Dynon Avionics SkyView. Dynon Avionics SkyView 11 stron. Autopilot in-flight tuning procedures
Drukuj stronęAutopilot In‐Flight Tuning Procedures
Detailed Explanation
1. Establish trimmed level flight on a fixed heading
You should start the procedure by placing the aircraft in level flight, in neutral trim, on a fixed
heading. Try to maintain a constant heading during the procedure.
2. Engage the Flight Director (FD) in TRK and IAS mode
To engage the flight director in TRK and IAS mode:
1. Enter the AP Menu (MAIN MENU > AP)
2. Press the FD button
3. Press button 4, ROLL, then button 3, TRK
a. It should be highlighted and look like
4. Press the BACK button
5. Press button 5, PITCH, then button 3, IAS
a. It should be highlighted and look like
6. Example: if the Flight Director were engaged in TRK mode on a TRK of 360 degrees and
an IAS of 100, the top bar would look like this:
a.
3. Engage the Autopilot (AP)
To engage the autopilot:
1. Enter the AP Menu (MAIN MENU > AP)
2. Press AP
3. The AP and FD buttons should look like
4. Allow a few minutes of stable flight under AP control
Ensure that you are not affecting the autopilot's control of the pitch axis, so you can determine
the autopilot's IAS hold performance.
5. Increase IAS target by 10 knots
Change the IAS bug to 10 knots above the current IAS target.
1. Configure a joystick to control the IAS bug. The label above the joystick should read
(IAS).
2. Turn the joystick clockwise until the IAS bug reads 10 knots higher than it did when the
Flight Director was engaged.
3. The aircraft should immediately begin descending toward the new IAS target.
1‐8 SkyView Autopilot In‐Flight Tuning Guide ‐ Revision A