aireRyder F0042 Podręcznik - Strona 7

Przeglądaj online lub pobierz pdf Podręcznik dla Wentylator aireRyder F0042. aireRyder F0042 9 stron.

Drukuj stronę

Fan Light Installation:

WARNING:

As per EPACT 2005 requirements, this fan light has a built-in current limiting device to conserve

energy. The fan light will not operate if the combined wattage of the installed bulbs exceeds 190

Watts. If the fan light shuts off shortly after being switched on, it may be due to excessive current

demand. You should replace the light bulbs with lower wattage bulbs.

Switch Box

Light Kit

Fig.14

Attach the switch box to light kit, secure

them with a washer and a hex nut.

NOTE: To avoid the fan switch chain

touching the light kit's arm. The fan

switch chain on the switch box should

be staggered the light kit's arm when

attach the switch box.

Forward

Switch Box

Light Switch Chain

Fig.17

Hex Nut

Washer

Fan Switch

Chain

Fig.15

Slide Switch

Reverse

Fan Switch

Chain

Fig.16-a

Turn ON the electric circuit at the

main fuse or circuit breaker box.

Terminals

Switch Box

Screw

ST 48 Bulb Max.60W

(Included)

Forward

Fig.16-b

The slide switch on switch box sets direction of fan rotation.

Select the desired direction of fan rotation.

Push the slide switch left for " Forward" and right for "Reverse".

Note: Wait for fan to stop before reversing the direction of blade

rotation.

The pull chain controls the fan speed as follows:

1 pull – High, 2 pull – Medium, 3 pull – Low, and 4 pull – Off.

To turn the light kit "ON" or "OFF", pull the chain that is on the

light kit.

Caution: If you install a remote control or a wall control for

this fan, pull the pull chains to "high speed" of the fan

motor and "on" of the fan light.

PAGE: 7 / 9

Connect wires :

--- Connect the red (hot) wire

from the switch box to the

black (hot) wire from fan

light with a wire nut.

Wire Nut

--- Connect the white (neutral)

wire from the switch box to

the white (neutral) wire from

Light Kit

fan light with a wire nut.

Carefully put the wires into the

switch box. Then connect the

two terminals respectively from

the motor and the switch box.

Secure the switch box to

motor with switch box screws.

Install bulbs (included). See

relamping label at socket

area or packaging for

maximum allowed wattage.

Reverse

Slide Switch

160310