aireRyder FN66636 Instrukcja instalacji i użytkowania - Strona 4
Przeglądaj online lub pobierz pdf Instrukcja instalacji i użytkowania dla Wentylator aireRyder FN66636. aireRyder FN66636 8 stron. Ceiling fan model borealis
Drukuj stronę
Fig.9
1. Make house wire connections. Follow diagram on the right and make sure that all exposed wires are
tightened by screw on terminal block.
Note:
a.) The terminal block shown in right graph is pre-installed on the mounting bracket.
b.) After wiring is completed, gently push wires into hanger bracket with terminal block facing upward (if applicable).
2. a.) Slide receiver through hanger bracket as shown.
b.) Plug the male connection of receiver wires into the female connector of motor wires.
c.) Insert the infra-red sensor into the hole on the canopy
d.) Make fixture wire connection. Plug the male connector into female connector.
(Do not force it into wrong receptacle as it will cause damage.)
Fig.10
Hanger Bracket
Canopy
Key Hole
Slot
Canopy Screw
Remove one canopy screw (for
later use), then push the canopy
upwards by inserting canopy screw
head left in hanger bracket into key
hole slot, rotate the canopy till the
hole in canopy aligns the hole in
hanger bracket, finally, secure the
canopy to hanger bracket with
previous canopy screw and tighten
the other canopy screw.
Attach the decorative cap to
canopy,rotate it clockwise until tight.
F
A
N
C
O
171213
Canopy Screw
Decorative Cap
Remove the glass holder plate from
motor by removing three set screws.
Fig.11
Moto r
Glass Holder
Plate
Set Screw
4