GAME SolarPRO 4512 Instrukcja obsługi - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Podgrzewacz basenowy GAME SolarPRO 4512. GAME SolarPRO 4512 12 stron. Pool heater

INSTALLATION INSTRUCTIONS

Heater – Filter – Pool Layout

The system layouts below will help you install the solar heater(s) to your above ground pool

BEFORE INSTALLING SOLAR HEATER

AFTER INSTALLING SOLAR HEATER

These instructions assume that the pool and filter system are already assembled

and there is a hose attached to the pool return (pool water inlet)

Place the solar heater in a location where it will receive the greatest amount

of sunlight and at least 10 feet away from pool

NOTE: Hose connectors may come preinstalled.

1) Heater - Filter Pump Connection

a) Turn off filter pump

b) Block water flow at both the pool return inlet and the filter pump outlet

to prevent water from flowing through the hoses

c) Detach the pool return hose from your filter system and set aside

NOTE: If you are using an INTEX® filter, remove the

hose adapter from the filter port as well.

d) Locate the side hose connector and insert it into the side hose connection

opening – it is keyed to fit one way only – and turn counterclockwise to lock

into place It will turn about a ¼ turn to fully lock in place

e) Locate long filter hose and attach between pump (the port where the pool return

hose was previously connected ) and the side hose connector using

the included hose clamps

NOTE: depending on the size of your hose, the 1¼"-1½" reducer may need

to be used. Insert the reducer inside of the long filter hose and attach using

hose clamp. Apply a small amount of silicon based lubricant to the outside

of the side connector to allow an easy fit (see figure 1).

SAVE THESE INSTRUCTIONS

Meijer.com

NOTE: Not shown to scale

Reducer

(if needed)

Side Hose

Connection

Hose from

Filter/Pump

Hose Clamp

Figure 1