GAME SolarPRO XD3 Instrukcja obsługi - Strona 4
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Podgrzewacz basenowy GAME SolarPRO XD3. GAME SolarPRO XD3 12 stron.
Drukuj stronę1.
SAFETY WARNINGS
READ ALL WARNINGS BELOW. FAILURE TO DO SO COULD RESULT
IN SERIOUS PERSONAL INJURY OR DEATH.
•
Carefully read and adhere to all CAUTION and NOTE notices located throughout this manual.
Failure to comply with these instructions can cause serious injury, death, or damage to the unit.
•
Do NOT allow children to operate this product.
•
Always turn the filter system to a setting that does not allow flow to the pool return when installing
or working on the solar heater.
•
Install product away from the pool to prevent children from using the heater as a way to access the pool.
•
NEVER service this unit with the pool pump running.
•
Do not use any petroleum based lubricant. Petroleum based products will destroy plastic parts.
THESE CAUTION WARNINGS ARE NOT INTENDED TO INCORPORATE ALL POSSIBLE INSTANCES FOR RISK AND/OR SEVERE
INJURY. THE POOL OWNER SHOULD ALWAYS EXERCISE CAUTION AND COMMON SENSE WHEN UTILIZING THEIR SWIMMING
POOL AND OPERATING EQUIPMENT.
IMPORTANT: WHEN CONNECTING MULTIPLE SOLAR HEATERS, A GAME BYPASS KIT IS REQUIRED. CONTACT GAME CUSTOM-
ER SERVICE, 1.888.339.2546 FOR MORE INFORMATION.
2.
GENERAL INFORMATION
This manual provides information relating to the installation, utilization and maintenance of our solar heater. We recommend you read
this manual in its entirety and keep it for future reference.
The solar heater you just purchased for your above ground pool is simple to install and effortless to operate once connected. The instal-
lation instructions included in this manual are based on a few assumptions: 1) you have an existing above ground pool that is com-
pletely set up and filled with water, 2) your above ground pool is equipped with a pump-operated water filtering system, and 3) you
have the necessary hoses needed to feed water in and out of your pool and filter system.
These assumptions are necessary as the solar heater, once installed, will be completely dependent upon your pool's filter pump to push
water in and through the heater's solar coils.
NOTE: Approved for use with any cartridge or sand filter up to 1.5 HP max.
Use of any other type of pump will void the warranty.
How It Works
When properly installed, the solar heater will be connected to your filter and your pool by two hose connections: one hose will feed
cold, filtered pool water from your pump into one port of the solar heater. The other hose will feed sun warmed water from the other
port of the solar heater to your pool via the pool return inlet in your pool. As cold water is fed into the solar heater, it travels through
the solar coils where it is heated by the sun before it is delivered back into your swimming pool.
Unpacking Your Solar Heater
Carefully remove the product and all component parts from the box. Make certain all parts are present before beginning assembly. (see
Section 2, Parts List/Reference).
Tools & Equipment Required
The following items are not included with your new solar heater, but will be required for proper installation and operation:
•
#2 Phillips screwdriver
•
¼" Flat head screwdriver
•
Silicone based lubricant
SAVE THESE INSTRUCTIONS
4