GAME 4301 Instrukcja obsługi - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Termometr GAME 4301. GAME 4301 8 stron. Digital wireless thermometer

SPECIFICATIONS

Range of temperature measurement:

Receiver:

Remote sensor:

Transmission:

Resolution:

Battery life:

Note

• Always read the owner's manual carefully before operating the unit.

• Avoid placing the receiver near interference sources/metal frames such

as computer or TV sets.

• The receiver loses its time information when the battery is removed.

• The unit will automatically exit all menus after 8 seconds without adjustment.

• The remote sensor transmits every 2.5 minutes if the temp change is less than

0.5 °C / 1.1 °F. If the temperature change is more than 0.5 °C / 1.1 °F it will transmit

every 30 seconds. The remote sensor will measure temperature every 10 seconds.

For first time installation, always insert batteries in the receiver unit and then the

remote sensor. The receiver will seek a sensor within range.

1. Slide open the battery cover at the back of the unit.

2. Install two (2) AA batteries according to the polarity indicated.

3. Replace the battery cover.

• Place the sensor as close to the receiver as possible.

• The battery compartment is in the tubular casing of sensor (see Exploded View

on previous page). Remove sensor cap by releasing screw located in the center

of cover. To remove battery cover, unscrew and remove all 4 screws. Locate the

plastic clip at the center of cover, insert screwdriver into circular opening and

gentle pry upwards to release battery cover.

• Install two (2) AAA batteries according to the polarity indicated.

• Tighten the screws on the battery cover in the order indicated (1 thru 4) on the

bottom of the battery cover. Then replace the sensor cover.

• The red LED on the remote sensor will flash when it transmits a signal. Tempera-

ture of the remote sensor will be updated and displayed on the sensor's LCD.

• If the remote sensor does not automatically pair with the receiver, hold the

"Channel" button for 3 seconds until it beeps. Release the button. Then hold the

"Tx" button on the remote sensor. They will beep again once paired.

• Press the "°C/°F" button on the back of the remote sensor to change from

Fahrenheit to Celsius.

-0 °C to 50 °C (32°F to 122°F)

-50 °C to 70 °C (-58°F to 158°F)

30M (100 ft.) open area, RF 433 MHz

0.1 degree

12 months (alkaline batteries recommended)