Deagostini Model Space HUMMER H1 Podręcznik - Strona 17

Przeglądaj online lub pobierz pdf Podręcznik dla Zabawka Deagostini Model Space HUMMER H1. Deagostini Model Space HUMMER H1 18 stron.

Drukuj stronę

HUMMER H1: STEP BY STEP

With the brake rod still attached through

the brake lever, place the throttle servo

horn onto the throttle servo. The servo horn

should sit perfectly at right angles to the

edge of the radio box.

Hold the brake lever level (see dotted lines), then push the

stopper, silicon tube and brake collar up against the hoop of the

brake lever.

Make sure all the cables

are safely inside the

radio box, then close the

box by adding the lid

(see arrow).

Push the servo horn down so that it slots

into place, with the output shaft on the top

of the servo beneath. At this stage, the brake

rod will be set at an angle.

Prepare the power

switch and battery box

supplied with Stage 45,

and join the connectors

of both. There is only

one way the connectors

will fit correctly.

Place the servo horn screw into the

central hole of the servo horn, then

tighten with a screwdriver. This is a

temporary assembly, so only tighten

lightly at this stage.

Once in position, tighten the 3mm set screw with the 1.5mm Allen

key to secure the parts.

Fit both radio box collars

(Stage 46) over the

cylindrical projections

at the rear of the radio

box. The wider side of the

collars should sit against

the body of the box.

221

Place the power switch

and battery box inside

the space at the rear of

the radio box, as shown.

It is not necessary at this

stage to connect the

servo cables.

™