HIKOKI WR 16SE Instrukcja obsługi Instrukcja obsługi - Strona 16

Przeglądaj online lub pobierz pdf Instrukcja obsługi Instrukcja obsługi dla Sterownik udarowy HIKOKI WR 16SE. HIKOKI WR 16SE 20 stron.

English

Using the hook

(1)

Removing the hook.

Remove the screws ﬁ xing the hook with Philips

screw driver. (Fig. 6)

(2)

Replacing the hook and tightening the screws.

Install securely the hook in the groove of power tool

and tighten the screws to ﬁ x the hook ﬁ rmly.

MAINTENANCE AND INSPECTION

Inspecting the socket

A worn or deformed hex or a square-holed socket will not give an adequate tightness to

the ﬁ tting between the nut or anvil, consequently resulting in loss of tightening torque. Pay

attention to wear of socket holes periodically, and replace with a new one if needed.

Inspecting the mounting screws

Regularly inspect all mounting screws and ensure that they are properly tightened. Should

any of the screws be loose, retighten them immediately. Failure to do so could result in

serious hazard.

Maintenance of the motor

The motor unit winding is the very "heart" of the power tool.

Exercise due care to ensure the winding does not become damaged and/or wet with oil or

water.

Replacing supply cord

If the replacement of the supply cord is necessary, this has to be done by the manufacturer

of this agent in order to avoid a safety hazard.

CAUTION

In the operation and maintenance of power tools, the safety regulations and

standards prescribed in each country must be observed.

Screw

Hook

Fig. 6