Gree NEO18HP230V1A Instrukcja obsługi - Strona 10

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Pompa ciepła Gree NEO18HP230V1A. Gree NEO18HP230V1A 12 stron. High-wall ductless air conditioning & heating system
Również dla Gree NEO18HP230V1A: Skrócona instrukcja obsługi (2 strony)

Drukuj stronę

TWD-0813-033 Neo Manual REV:Layout 1 9/27/13 11:15 AM Page 19

CARE AND CLEANING

WARNING

CAUTION

WARNING

C UTION

• Turn off power and disconnect unit from power source before cleaning. Failure to do so

could cause electric shock.

• Never spray water on either indoor or outdoor unit.This could cause damage or unit failure.

• Never use abrasive cleaners on indoor or outdoor unit. Use only slightly damp, clean,

soft cloth or very mild cleansers.

CLEANING THE FRONT PANEL

1.To remove front panel for cleaning, lift up and pull out.

2. Wash the panel with water, a soft cloth or soft brush. Use only very mild cleaners.

Then dry completely.

NOTE: Take down the display panel before cleaning. Never use water above 113°F (45°C)

because it may cause discoloration or damage to surface.

3. Replace front panel. Fit the sides of the panel into the slots and push into place.

CARE AND CLEANING

CLEANING THE PRIMARY AIR FILTER

Cleaning is recommended every three months.

NOTE: If the indoor unit is exposed to excessive dust, cleaning may be necessary more often.

Use caution when removing the filter to avoid sharp metal extensions.

1. Remove air filter by tilting up the unit cover and pulling filter free.

2. Clean air filter using a vacuum or warm water and mild cleaner.Air dry filter in the shade.

Never use fire to clean stains or debris on filter.

3. Reinsert the filter being, careful to align

properly, then close unit.

CLEANING OPTIONAL PHOTOCATALYTIC FILTER

Clean every 2 weeks for the best results.

1. Remove photocatalytic filter from front face of primary air filter.

2. Clean lint and dust from air filter using vacuum.

NOTE: Do not get photocatalytic filter wet.

3. Place photocatalytic filter in direct sunlight for 60 minutes to energize catalyst.

4. Re-install the photocatalytic air filter on the unit by inserting it back on the primary air filter.