Maiwe MIEN2208 Series Podręcznik użytkownika - Strona 16
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Przełącznik Maiwe MIEN2208 Series. Maiwe MIEN2208 Series 19 stron. Industrial ethernet switch
Również dla Maiwe MIEN2208 Series: Podręcznik użytkownika (5 strony)
Drukuj stronę
MIEN2208 Series Unmanaged Industrial Ethernet Switch
is a 10Base-T / 100Base-TX Ethernet RJ45 interface, which uses a DC
network cable to connect to the terminal equipment and a crossover network
cable to connect to the network equipment.
Connecting Power
MIEN2208 series switches use power according to the instructions on the
product label. When all other cables are connected, the power can be
connected
3.2.2. Fiber connecting
The1- fiber , 2-fiber and 4-fiber models of MIEN2208 series switches
provide 100Base-FX full-duplex single-mode or multimode fiber interfaces. The
type of optical fiber interface can choose SC / ST / FC according to demand.
Attention
This switch uses a laser to transmit signals on fiber optic cables. The
laser meets the requirements of Class 1 laser products, and normal
operation is not harmful to the eyes. However, when the device is
powered on, do not look directly at the optical transmission port and the
end face of the fiber terminator.
The steps to connect pluggable fiber optic modules are as follows:
Remove and keep the rubber sleeve of the SC / ST / FC port. When not
in use, put on a rubber sleeve to protect the fiber optic terminator
Check whether the fiber terminator is clean. Lightly moisten a clean
paper towel or cotton ball and gently wipe the cable plug. A dirty fiber
terminator will reduce the quality of the optical transmission and affect the port
performance
Connect one end of the optical cable to the optical fiber interface and the
other end to the optical fiber interface of another device
After the connection is completed, please check the LINK / ACT indicator
of the corresponding optical port on the front panel.
3.3. Simple Test
3.3.1. System self-check
When the device is powered on, all service port indicators on the front
panel flash one at a time, indicating that the switch has been powered on.
When the RUN indicator flashes, the switch starts to work normally.
3.3.2. Copper port test
As below picture,Power on the switch, connect any two copper ports to the
network ports of the two test computers through a directly connected network
cable, and send Ping commands to each other. Both parties can correctly ping
- 12 -