Maiwe MIEN2208 Series Podręcznik użytkownika - Strona 3

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Przełącznik Maiwe MIEN2208 Series. Maiwe MIEN2208 Series 5 stron. Industrial ethernet switch
Również dla Maiwe MIEN2208 Series: Podręcznik użytkownika (19 strony)

Maiwe MIEN2208 Series Podręcznik użytkownika
Hardware installation
Installation Precautions
To prevent equipment damage or personal injury caused by improper use, observe
the following precautions:
During the installation process, you need to wear anti-static gloves or anti-static
gloves, and power-off the switch.
Please make sure that the input voltage is within the input voltage range marked
on the switch.
The transmission distance has a certain relationship with the connected wire. It
is recommended to use a standard Cat5e/6 network cable.
The equipment must be grounded for lightning protection, otherwise the
protection level of the equipment will be greatly reduced; please use a wire of No.
20 or more to connect the grounding terminal to the ground.
The power line, ground line and signal line are laid out separately and the
distance is not less than 5cm.
Device installation
Tilt the switch upwards so that the upper end of the buckle is fastened to the
upper end of the DIN rail.
The lower end of the back buckle is buckled into the DIN rail.
Device connection
Network cables connection
Connect the optical fiber and network cable to the port in the correct
Catagory5 direct connection
Optical fiber connection
Connect the optical fiber to the corresponding optical fiber interface. The optical
fiber interface is used in pairs (TX and RX as a pair), TX is optical receiver, RX is
optical sender.
Catagory5 crossover connection