MAJAR VS700RL Instrukcja instalacji, obsługi i serwisu - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja instalacji, obsługi i serwisu dla Rozrzutnik MAJAR VS700RL. MAJAR VS700RL 14 stron. Sand spreader

The installation and commissioning of the tool are the responsibility of the MAJAR reseller. The machine must

be delivered fully mounted, lubricated and adjusted to the normal operating conditions.

COUPLING OF THE MACHINE

WARNING

Keep your hands away from the linkage

Hitched model: - Linkage height: 40 - 50 cm from the ground

• Move back the tractor until the lower arms are at a few cm of the turning ring linkage. Stop the engine, shift

the transmission to neutral, apply the handbrake and remove the key.

• Couple the Sand spreader to the tractor with a high diameter axle and a security pin. Lift the support stand:

place the pin and the clamp, mount the support stand and place the clamp pin and the pin in the lowest hole of

the stand (C)

Semi-mounted:

- Make sure that the tractor lift is able to lift the charged

machine (see voir table characteristics).

- The Sand Spreader must be hitched to a agricultural tractor

with a 3 point linkage Cat. I.

• Move back the tractor until the lower arms are at a few cm of the

linkage (B).

• Stop the engine, shift the transmission to neutral, apply the

handbrake and remove the key.

• Couple first the non adjustable lower arms. Couple next the variable

part adjusting the length if necessary. Place next the push bar (D)

adjusting the length on the sand spreader side with axle A and then on

the tractor side.

• Lift the support stand: place the pin and clamp, mount the support

stand and place the clamp pin and the pin in the lowest hole of the

stand (C)

Hydraulic tilting:

DANGER

injury. If you are injured, consult immediately a doctor.

- Make sure that the cylinder is correctly placed on the spreader housing depending on the model

hitched or semi-mounted (see illustration below)

- Actuate a several times the remote of the double-acting control valve to release the pressure and

disconnect the two hoses.

- Place the transport bar A

Hitched model: Fixation « Low »

INSTALLATION AND COMMISSIONING

Danger of crushing hands

A jet of hydraulic fluid caused by leaking may penetrate the skin and cause fatal

Semi-mounted model: Fixation « High »