Airfield 95A251 Instrukcja montażu - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja montażu dla Zabawka Airfield 95A251. Airfield 95A251 8 stron.

Drukuj stronę

Settings:

1.Brake: ON/OFF

* ON- Sets the propeller to the brake position when the throttle stick

(Recommended for folding props).

* OFF- Sets the propeller to freewheel when the throttle stick is at the minimum position.

2.Battery type: LiPo or NiCad/NiMh

* NiCad/NiMH – Sets Low Voltage protection threshold for NiCad/NiMH cells.

* LiPo – Sets Low voltage protection threshold for LiPo cells and automatically detects the number of

cells within the pack.

Note: Selecting the NiCad/NiMH option for the battery type, triggers the ESC to automatically set the

cutoff threshold to the factory default of 60%. The cutoff threshold can then be subsequently altered

through the Low Voltage protection function, if required. The ESC will read the initial voltage of the

NiCad/NiMh pack once it is plugged in and the voltage read will then be used as a reference for the cutoff

voltage threshold.

3.Low Voltage Protection Threshold ( Cutoff Threshold ):

Low / Medium / High

1) For Li-xx packs- number of cells are automatically calculated and requires no user input apart from

defining the battery type. This ESC provides 3 setting options for the low voltage protection threshold ;

Low (2.8V)/ Medium (3.0V)/ High (3.2V). For example : the voltage cutoff options for an 11.1V/ 3 cell

Li-Po pack would be 8.4V (Low)/ 9.0V(Med)/ 9.6V(High)

2) For Ni-xx packs-low / medium / high cutoff voltages are 50%/60%/65% of the initial voltage of the

battery pack.. For example: A fully charged 6 cell NiMh pack's voltage is 1.44V x 6=8.64V,when "LOW"

cutoff voltage is set, the cutoff voltage is: 8.64V x 50%=4.3V and when "Medium" of "High" is set, the

cutoff voltage is now 8.64V X 65%=5.61V.

4. Restore factory setup defaults:

Restore- Sets the ESC back to factory default settings;

Brake：

Battery type Detect：

Low voltage Cutoff threshold：

Timing Setup：

Soft Acceleration Start Up：

Governor Mode ：

Frequency ：

Low Voltage Cutoff Type：

5.Timing Setup : Automatic/ Low / High.

* Automatic (7-30 deg) – ESC automatically determines the optimum motor timing

* Low (7-22 deg) – Setting for most 2 pole motors.

* High(22-30 deg)-setting for motors with 6 or more poles.

In most cases, automatic timing works well for all types of motors. However for high efficiency we

recommend the Low timing setting for 2 pole motors (general in-runners) and high timing for 6 poles

and above (general out-runners). For higher speed, High timing can be set. Some motors require

different timing setups therefore we suggest you to follow the manufacturer recommended setup or use

the automatic timing setting if you are unsure.

Note: Run your motor on the ground first after making any changes to your motor timing!

6.Soft Acceleration Start ups: Very Soft / Soft Acceleration/ Start Acceleration

OFF

LiPo with Automatic Cell

Medium (3.0V/60%)

Automatic

Soft Acceleration

RPM OFF

8kHz

Reduce power

at the minimum position