CentralPneumatic 68019 Instrukcja obsługi - Strona 13
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Pistolet do gwoździ CentralPneumatic 68019. CentralPneumatic 68019 20 stron. 2-in-1 18 gauge nailer-stapler
Również dla CentralPneumatic 68019: Instrukcja konfiguracji i obsługi (19 strony)
Drukuj stronę
Loading the Tool
TO pREVENT SERIOUS INJURy FROM AccIDENTAL OpERATION, BEFORE LOADING:
• Wear ANSI-approved safety goggles with side shields.
Other people in the work area must also wear ANSI-approved impact safety goggles with side shields.
• Release the trigger.
• Detach the air supply.
• Attempt to fire the Tool into a piece of scrap wood to ensure that it
is disconnected and is incapable of firing any fasteners.
1. Depress the Latch (64) and pull back
on the Moveable Magazine (55), pulling
it out of Fixed Magazine (52).
2. Insert the fasteners into the Moveable Magazine.
If loading staples, fit the crown of the staples so
they fit over and ride on the rail of the Magazine.
General Operating Instructions
1. Before each use, test the tool as
directed in the prior section.
2. If an automatic oiler is not used, add
a few drops of Pneumatic Tool Oil to the airline
connection before use. Add a few drops
more after each hour of continual use.
WARNING! TO pREVENT
SERIOUS INJURy: Keep second hand
away from tool discharge area,
especially if holding workpiece.
Tool applies extreme force to fastener,
and fasteners may deflect or fire in
an unexpected direction.
cAUTION! TO pREVENT INJURy: Do not hold tool
near body while firing. Tool recoil can cause injury.
3. Position tool at desired fastener location
and depress the Safety Nosepiece fully
against the workpiece.
Squeeze the trigger to fire a fastener.
Item 68019
For technical questions, please call 1-800-444-3353.
3. After the nails or staples are loaded,
slide the Moveable Magazine back into
Fixed Magazine until the Latch snaps back
into place, locking the Moveable Magazine.
Note: The small window gauge on the left side
of the Moveable Magazine indicates how many
fasteners remain inside Nailer-Stapler.
4. If the tool requires more force to accomplish
the task, verify that the tool receives sufficient,
unobstructed airflow (CFM) and increase the
pressure (PSI) output of the regulator up to the
maximum air pressure rating of this tool.
cAUTION! TO pREVENT INJURy
FROM TOOL FAILURE:
Do not exceed the tool's
maximum air pressure rating.
If the tool still does not have sufficient force
at maximum pressure and sufficient airflow,
then a larger tool may be required.
5. After use, to prevent accidents:
a. Release the trigger.
b. Detach the air supply.
c. Attempt to fire the Tool into a piece of scrap
wood to ensure that it is disconnected
and is incapable of firing any fasteners.
d. Release the trigger again.
e. clean external surfaces with clean, dry cloth.
f. Store indoors out of children's reach.
Page 13