Majestic CKRUBY35 Instrukcje instalacji - Strona 2

Przeglądaj online lub pobierz pdf Instrukcje instalacji dla Kominek wewnętrzny Majestic CKRUBY35. Majestic CKRUBY35 3 stron.

KIT COMPONENTS (Shown in Figure 1)
(1) Basepan Assembly
(1) Burner Assembly
(1) False Back
(1) Exhaust Baffle
(1) Bag Onyx Glass Media
(1) Bag Diamond Glass Media
(1) Bag 1/2 inch screws (25 screws per bag)
(1) Conversion Plate
(1) Stone Placement Jig
(1) Propane Orifice - .058", 1.55 mm
(1) NG Orifice - 38, 37
(2) Insulation Board (CKRUBY35 Only)
STONE
PLACEMENT
JIG
ROCK STOP
JIG
BURNER
ASSEMBLY
ADDITIONAL COMPONENT - 35 in. ONLY
INSULATION
BOARD
Figure 1. Contemporary Kit Metal Components
2
Majestic • CKRUBY30, CKRUBY35 Contemporary Kit Instructions • 2542-939 Rev. B • 2/19
EXHAUST
BAFFLE
FALSE BACK
PILOT
HOOD
BASE PAN
ASSEMBLY
Installation Instructions
1. Remove base refractory.
2. Remove the screws that attach the base pan to the
burner and lift the base pan out of the appliance.
3. Remove the burner bracket screw. Slide burner to the left
and lift out of the appliance. Be careful not to damage the
pilot sense rod.
4. Remove the exhaust baffle and replace with contem-
porary exhaust baffle. See Figure 2.
5. Remove the orifice using a 3/8 in. wrench and replace
with correct orifice for gas type. See BTU specification
table on page 1.
6. Adjust the air shutter and install contemporary burner
assembly. See BTU specification table on page 1.
7. Install contemporary base pan assembly.
Note: Install insulation board behind false back for
CKRUBY35 kit.
8. Install false back. See Figure 2.
EXHAUST BAFFLE
FALSE BACK SCREWS
Figure 2. Screw Location
9. If installing the glass refractory kit, refer to the installa-
tion instructions that came with the kit and install now.
10. If installing logs, refer to the instructions with the kit
and install now.
11. Install glass media. When using multiple media col-
ors, mix them prior to installation. For optimal per-
formance and flame appearance, ensure it is spread
evenly. See Figure 3.
Media Chart
Models
CKRUBY30 (NG)
CKRUBY30 (Propane)
CKRUBY35 (NG)
CKRUBY35 (Propane)
CAUTION
P
:
lace only one thin layer of media over the
burner and base pan when using Propane gas. Excess
media on burner and base pan may cause sooting. One
t
hin layer of media may require less media than indicated
in the above media chart.
SCREWS
Media
Quanity (Bag)
1-1/4
less than 1-1/4
1-1/2
less than 1-1/2