Majestic MARQ36IN Instrukcja montażu szkła ogniotrwałego - Strona 2
Przeglądaj online lub pobierz pdf Instrukcja montażu szkła ogniotrwałego dla Kominek wewnętrzny Majestic MARQ36IN. Majestic MARQ36IN 5 stron. Ember lighting & refractory upgrade kit
Również dla Majestic MARQ36IN: Instrukcja instalacji (7 strony)
Drukuj stronę4. To begin the install of the rear light cover, first remove
the back center screw that fastens the inner glass as-
sembly down to the bottom of the firebox. Retain this
screw as you will need to refasten it in later step. Lay
the rear light cover down on the inner glass assembly
but underneath the light cover. See Figure 3.
REAR LIGHT COVER
INNER
LIGHT COVER
GLASS
ASSEMBLY
Figure 3 Installing Rear Light Cover
5. The rear light cover should slide between the inner
glass assembly and the light cover so that the clear-
ance hole of the rear light cover lines up with the hole
of the inner glass assembly where you removed the
screw back in Step 4. You may want to lift up on the
light cover so that the rear light cover can fully slide
into postition underneath it.
6. Refasten the screw that you had saved before from
the inner glass assembly. This screw will hold down
the rear light cover and the inner glass assembly down
to the firebox bottom. See Figure 4.
Figure 4 Re-install Back Center Screw
7. Locate the grate / burner assembly that had been set
aside and re-engage the burner on orifice on the back
wall of the firebox. Fasten the front grate legs down to
the firebox bottom using the existing holes and screws
you retained from Step 2.
2
Majestic • GLMQ36, GLMQ42 Glass Refractory Kit Instructions • 2270-933 Rev. D • 1/19
SCREW
8. Place rear white refractory spacer with the arch down
as shown in Figure 5. The holes in the spacer should
align with the screws in the firebox when installed
correctly.
Figure 5 Rear Spacer
9. Ensuring that the rear spacer is properly in place and
tight to the rear wall, install the rear glass panel with
arch down as shown in Figure 6.
Figure 6 Rear Glass Panel