Adexa ZB10 Instrukcja obsługi - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Kostkarka do lodu Adexa ZB10. Adexa ZB10 6 stron.

Drukuj stronę

3. Please adjust the feet when placing the ice maker somewhere,

otherwise the water level in water box will be effected and so do the

ice. Before using the ice maker for the first time, you should wait

about 12 hours after positioning it in a proper place.

4. Clean the inner liner,

ice storage basket,

water storage tank,

water box, ice pusher

and evaporator.

5. Power:AC220-240V/50Hz

6. The rated capacity of wire should be over 10A.The wire could be

consisted by single ply or multiplies. The rated current of fuse is 5A.

7. Fill water into water storage tank.

Fill drinkable water only. Make

sure that the water level is not over

the fill max in the cabinet or not over

the bottom of ice storage basket.

8. The plug must be easy to reach when you have installed the ice maker.

TROUBLE AND SHOOTING

TROUBLE

CAUSE

The power indicator

is light. The

The voltage is out of

compressor works

the limitation

abnormally with

noise buzz.

There is no water or water

Water Low

level is too low.

indicator is light.

There is too much ice.

Ice full indicator

The temperature is too low

is light.

The power is not well-

There is no indicator

connected.

light on the board.

The water-box is blocked

by the ice cubes.

The indicators of

water shortage and

ice full glitter at the

The water box can not tilt.

same time.

The ice is made

Ice making time is too long.

in block.

Refrigerant leaks.

Compressor runs,

There is block in

but no ice is made.

refrigerating system.

Note: It is normal that the temperature of the compressor surface could be 70 -

REMEDY

Stop the ice maker and restart it

until the voltage is normal.

Fill water and it will restart to

work automatically.

Take out some ice.

Put the ice maker to a warmer

place.

Maker the power well-connected.

Check relative parts after unplug-

ging.Take out some ice cubes that

block the water box or ice pusher

carefully.

Turn the water box slightly by

hand. 3-5 minutes later try to

restart.

Stop the machine and reset the ice

making time. Start the machine after

the ice block has been melted.

Recharge refrigerant and make

leakage testing. Charge N to check

whether the system is blocked.

Replace the dryer-filter. Check

whether the fan is working.

℃ 90℃ when it is working.