Majestic Appliances MJ-9200W Instrukcja obsługi - Strona 7

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Spryskiwacz Majestic Appliances MJ-9200W. Majestic Appliances MJ-9200W 20 stron. Separate/stacking washer
Również dla Majestic Appliances MJ-9200W: Instrukcja instalacji (6 strony), Instrukcja obsługi (19 strony)

Drukuj stronę

:a| rig/Removing

Gettin

in s ready

appliance

(continued)

install

your

Plumbing

= Water,

Drains

WATER CONNECTION

! This appIiance can be used with either hot/cold or coldlcold connections

2 The hoses supplied have one straight end and one elbow end

The elbow end is meant to connect to the washer Be sure to connect the hot hose to the hot side of the appliance

itself, the cold side to the cold connection

(See picture)

The straight end to the 3/4" BSP standard hose bib thread

Brass pressure reducers and

3 MAKE SURE WASHERS ARE INSTALLED

IN EACH END OF THE SUPPLY HOSES. elbow ends of supply hoses

4 An optional "F"connector is available where cold only is desired.

5 Ensure that water connections are free from debris or sediment

6 BRASS PRESSURE REDUCERS MUST BE INSTALLED

TO PROTECT

COMPONENTS

INSIDE THE APPLIANCE.

IMPORTANT ! CHECK THREADS ON THE MACHINE, THE BRASS PRESSURE

REDUCERS AND THE SUPPLY HOSES TO ENSURE THEY ARE CLEAN° DO NOT

USE EXCESSIVE

FORCES. TIGHTEN BY HAND DO NOT USE POWER TOOLS.

Connection

of the drain hose

to standpipe

• Outlet end of drain hose (See figure 2) must be at least 20" above bottom of washer An air break must be provided at the standpipe

to avoid siphoning,

• Connect the drain hose to a standpipe (with internat diameter of at least 3 2cm or 1 1t4" min. diameter) with a minimum carry a v_ay

votume of 7 gallons. The top of the standpipe must be 20" minimum from the bottom of the appliance, Place drainhose for drainage

into a sink tub or standpipe, ensuring that there are not kinks or bends The free end must be at a height of 80cm from the floor, the

hose much be fixed in the appropriate hook on the upper part of the back panel (fig 4)

DO NOT INSERT

THE END OF THE DRAIN

HOSE MORE THAN 6" INTO

THE STANDPIPE.

INSERTING

MORE MAY CAUSE

THE APPLIANCE

HAVE INSUFFICIENT

DRAINAGE.

CORRECT

LEVELING

OF UNIT IS ESSENTIAL

It is important

for the machine

to be perfectly

level

The

angle of inclination

on the work surface

must not be

more than 2 degrees

For this reason the machine

fitted with adjustable

feet used for leveling

the machine

before

use, In the case of carpeted

flooring,

remember

to check that the ventilation

in the support

area is not

plugged

Page 6