AIRFLO PSV-8L Instrukcja obsługi i części - Strona 9

Przeglądaj online lub pobierz pdf Instrukcja obsługi i części dla Rozrzutnik AIRFLO PSV-8L. AIRFLO PSV-8L 17 stron.

OPERATORS MANUAL – PSV-8L (ELECTRIC)

b. Motor to Conveyor Shaft Drive

Chains-Adjust the chain tension for

the sprocket assembly which

transmits power to the conveyor

shaft by loosening the pillow block

bearing bolts and sliding the shaft

and bearings in the desired

direction. Then torque the 3/8-16

Pillow Block Bolts back to 236 Inch-

Pounds (20 Foot-Pounds) when

finished. See Figure 16. NOTE: Be

sure to maintain the horizontal

alignment of the shafts to the

chains. Failure to do so could result

in damage to the sprockets, motor,

shafts, and chains.

c. Motor to Spinner Shaft Drive

Chain-Correct tension for the

Drive Chain is also a 5/16"

deflection at the mid-point

between the two sprockets.

Adjust the chain by loosening

the Pillow Block Bolts as was

shown in Figures 11 and 12 and

Figure 16.

AIR FLO MANUFACTURING., CO INC.

slide the pillow blocks in the

desired direction.

6. Empty the spreader of all snow

control material when not in use to

prevent a frozen feed chain.

7. Wash out the spreader when it is

not in use and at the end of the

season to remove all snow control

materials. Thoroughly dry all metal

surfaces. Paint and oil all bare

carbon steel surfaces to help protect

against rust build-up. Properly store

spreader during the off-seasons.

8 |

P a g e