Majestic fireplaces UVHK36MN Instrukcja instalacji i obsługi - Strona 14
Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Grzałka gazowa Majestic fireplaces UVHK36MN. Majestic fireplaces UVHK36MN 20 stron. Vermont castings gas log heaters installation and operating instructions
Flame Check
A periodic visual check of the flames should be made. The pilot
flame should always be present when the appliance is in opera-
tion. (Fig. 10)
In normal operation (at full rate for approximately 15 minutes)
the following flame appearance should be observed:
Fig. 10 Correct pilot flame appearance.
����
�� ����� �����
����
When installed in a wood burning fireplace, the heat output
from the appliance can be controlled by the position of the flue
damper if it is installed in a wood-burning fireplace.
The damper setting should be fully closed for maximum heat
output, partially closed for less heat output and fully open for
minimum heat output.
The appliance may be used in a working solid fuel burning fire-
place with the flue damper closed only if unvented appliances
are permitted by local state and city codes. It may also be
Cleaning
CAUTION: Before cleaning or moving logs or other parts of the
unit, be sure to read the section on important safeguards.
Cleaning should be done before the logs are used each year
and after long periods of non-use.
All cleaning should be carried out when the appliance is cold.
Only limited cleaning will be required under normal use. Dust-
ing the front grate or the control knob panel may be required
occasionally. Do not use any cleaning fluids to clean the logs or
any other part of the appliance.
If the flames show any unusual shapes or behavior, or if the
burners fail to ignite properly, then the burner holes may require
cleaning. If this occurs contact your nearest dealer to get the
appliance serviced.
14
Main BurnerFlame: The flame should be yellow in color and
should extend about 6 inches above the large front log.
Typical flame shape as seen in Figure 11.
NOTE: For your safety, the appliance is equipped with an
oxygen depletion system. The system senses the oxygen in the
atmosphere and switches off the gas supply in case the level of
oxygen falls below a safe level. It must not be altered in any
way.
Natural Gas
Propane Gas
T279
Fig. 11 Correct log flame appearance.
Managing Heat Output
operated as a decorative appliance whose prime function lies in
the aesthetic effect of the flames when installed in a solid fuel
burning fireplace with the flue damper open. If unvented heat-
ers are not permitted, the fireplace vent damper must be locked
at a minimum vent area of 15 sq. ins.
Whenever the appliance is operated with the fireplace's flue
damper closed, glass doors - if present - must be open and
the outside air damper and the ash dump (if the fireplace is
equipped with either one) must be closed.
Maintenance
Alternatively, the appliance can be cleaned by removing the top,
front and rear logs. Handle the logs gently so as not to damage
them. Always lift each log by holding it carefully at each end.
After the logs are removed allowing access to the burner area,
use a vacuum cleaner to carefully remove dust, spider webs
and loose particles from the base, logs and from around the
burner. Gloves are recommended to prevent the ceramic fibers
that compose the logs from pricking your skin. If the skin is
pricked, wash gently with soap and water. Use extreme cau-
tion in clearing around the pilot (ODS). The pilot should not be
moved or altered from the original factory setting (Pilot to burner
preset location). The burner should not be removed or taken
out of it's locked and secure position (proper location of burners
are critical).
T123a
manual burner flame
10/29/03 djt
20008056
T123