Majestic fireplaces 20010752 Instrukcje instalacji - Strona 2

Przeglądaj online lub pobierz pdf Instrukcje instalacji dla Akcesoria do kominków Majestic fireplaces 20010752. Majestic fireplaces 20010752 4 stron. Fuel conversion kit lp to natural/natural to lp for model dv360

Drukuj stronę
2. Insure the rubber gasket (D) is properly positioned
and install the new HI/LO pressure regulator assem-
bly to the valve using the new screws (E) supplied
with the kit. Tighten the screws securely. (Ref. torque
= 25 in/lb) (Fig. 4)
3. Install the enclosed conversion label (F) to the valve
body where it can easily be seen. (Fig. 4)
E
F
Fig. 4 Replace regulator.
FC108
Honeywell Comfort Control Valve
SIT
1. Remove and replace plug on lower right hand side of
the valve; Red for LP and blue for NG. (Fig. 5)
regulator
2. Remove motor top cap. Depress and turn center
conversion
plunger until arrow points to correct screw. Red for
10/03
LP and Blue for NG. NOTE: Plunger will "snap" into
NG position when arrow is close to blue screw. It will
not "snap" at LP (Red) position. (Fig. 6)
Valve conversion is complete.
Motor Top Cap
Local/
Pilotstat
Remote Switch
Knob
Fig. 5 Comfort control valve.
FP1037
Honeywell
comfort valve
3/22/00 djt
2
D
FC108
Piezo Ignitor
OFF
•
LED
Plug
Antenna
FP1037
Center
Plunger
Blue - NG
Red - LP
Fig. 6 Depress and turn center plunger.
Burner Orifice Conversion
1. Remove the screws that secure the fettle and the
burner tube assembly, located behind the burner tube
assembly. Remove the two (2) screws that secure the
burner housing assembly to the base pan at the right
end of the burner housing assembly. (Fig. 7)
Burner Housing
Assembly
Burner Tube
Assembly
CO129
Fig. 7 Remove screws holding burner housing assembly and
burner tube assembly.
2. Remove the fettle and the burner tube assembly.
�����
Slide the burner housing assembly to the right and
����� ������
up to free the orifice.
���� ���
3. Using a 1/2" open end wrench remove the orifices.
(Fig. 8)
Front Burner Orifice
(Refer to Table on
Page 4)
CO130
Fig. 8 Burner orifice replacement.
Motor Top Cap
FP1037b
comfort valve
convert
3/6/01 djt
Pilot Location
Remove
Screws
Remove Screws
Rear Burner
Orifice
(Refer to Table
on Page 4)
�����
������ �������
���� ���
OFF
•
FP1037b