Green VOR-IC7000-G Instrukcja obsługi - Strona 11

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Rower treningowy Green VOR-IC7000-G. Green VOR-IC7000-G 15 stron. Full commercial indoor cycle

Drukuj stronę

INSTRUCTIONS FOR USE

VOR-IC7000-G

1) The VOR-IC7000-G is designed to be used as an "indoor cycling" cycle in fitness studios and health

clubs. It has a fixed wheel driven flywheel and should only be used under professional supervision.

2) Installation - It is important that the VOR-IC7000-G is correctly assembled and we recommend that

installation and assembly be carried out by suitably qualified personnel.

3) Handlebar and seat adjustment. It is important that the handlebar and seat are set at the correct

height for your body. Ask your instructor for assistance.

Adjusting the handlebar stem and seat post height - Make sure it is securely tightened and that there is

no lateral or vertical movement of the handlebar stem and seat post. Undo the quick release lever

which is locked in front of head tube. Slide the handlebar stem up or down to the required height and

then retighten.

The handlebar/stem position can also be adjusted forwards or backwards. Undo the Quick

Release lever located below the slider. Slide the handlebar/stem assembly forwards or backwards until

you reach the right position. Then securely re-tighten the Quick Release lever.

Adjusting the seat height - refer to above mention.

NOTE: There is a safety line engraved on the handlebar stem and seat post. Under no operating

condition should the handlebar stem and seat post ever be raised above this line.

4) Pedals and toe straps - Your feet should be securely positioned in the toe clips during the exercise.

Place your foot as far forward as you can into the toe-clip and then pull the strap tight.

5) Resistance system - VOR-IC7000-G bike is equipped with a durable belt, direct drive transmission

system. To adjust the exercising resistance on the completed indoor cycle, please refer to knob

assembly.

6) The VOR-IC7000-G should be operated on a level surface with no lateral movement. There is height

adjuster caps located on either side underneath the rear foot. Turn these caps clockwise or

counter-clockwise until the bike is totally stable on the ground.

7) Maintenance - Like any other mechanical cycling device, the VOR-IC7000-G should be regularly

maintained.

Ask your dealer for a detailed maintenance program.

www.GreenSeriesFitness.com

©June 2015

Call Toll free at (800) 269-7410

VOR-IC7000-G

Revision 1.1