Gamma 5003 Instrukcja obsługi - Strona 12

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Maszyny naciągowe Gamma 5003. Gamma 5003 20 stron. 6 point mounting
Również dla Gamma 5003: Instrukcja obsługi (20 strony), Instrukcja obsługi (19 strony), Instrukcja obsługi (20 strony)

Drukuj stronę

1. Machine Parts

STRING CLAMP ADJUSTMENT

the gap between the jaws. The clamp jaws should be cleaned periodically to be free from dirt,

oil, and any string coating for them to grip properly.

Note: The string clamps supplied with your Gamma stringing machine can accomodate tight

string patterns such as badminton. Depending on the string pattern, the clamp may spread the

strings slightly which will not compromise the quality of the string job.

STRINGING THE FRAME

Adjusting the Clamp Jaws

The GAMMA "Quick Action" Clamps will need minor

adjustments according to what string type, construction,

and gauge you are using.

To adjust the gap (clamping pressure) between the clamp

jaws, insert the string through the racquet as if you were

beginning the main strings. Clamp the strings and pull

tension. If the string slips through the jaws of the clamp,

tighten the clamp by compressing the clamp jaws together

by hand while turning the Adjustment Knob, in the clock-

Adjustment

wise direction. If the clamp leaves impressions or dam-

Knob

ages the string, it may be excessively tight and should be

adjusted by turning the knob counter clockwise to open

Weaving the Cross Strings

Weave the cross strings over and under the

main strings being careful to alternate the

weave direction of each consecutive cross

string so as to be opposite of the previously

installed cross string.

Once the final cross string is tensioned and

clamped, tie off at the appropriate hole speci-

fied by the racquet manufacturer.

Adjusting the Clamp Base Locking

Nut

In the event the Locking Lever rotation is

insufficient to ensure smooth operation of

the clamp base, very minor adjustments to

the Clamp Base Locking Nut can be made

with the supplied 17mm socket wrench.

Tighten or loosen the locking nut in very small

increments to provide more clamping pres-

sure or running clearance as needed.