Centrometal CentroPelet ZR12 Instrukcje techniczne dotyczące instalacji, użytkowania i konserwacji - Strona 12
Przeglądaj online lub pobierz pdf Instrukcje techniczne dotyczące instalacji, użytkowania i konserwacji dla Kuchenka Centrometal CentroPelet ZR12. Centrometal CentroPelet ZR12 12 stron.
Drukuj stronęMaintenance performed by the authorised service
WARNING !!!
During the first ignition it is necessary
to ventilate the environment well, since
during the first hours of operation
unpleasant odours could develop due
to fumes from the paint and the grease
in the wrapping..
If, during the normal operation of the stove, the
temperature of the smoke reaches 220°C
(a parameter which can be modified by a
technician) the smoke is modulated as follows:
• Smoke extraction motor set at maximum speed;
• Pellet loading gear motor at minimum speed;
• Tangential heat exchange fan at maximum
speed.
This procedure is to reduce the temperature of
the smoke. When this returns below the level
of 220°C, the stove will restore the speed of the
three motors returning them to the settings
before the level was passed.
If the electrical current cuts out, once it is
restored, the display will indicate a state of
anomaly and will read "Fire cool" (flame
present).
The suction will be increased to expel the
residual smoke.
Notes
Centrometal d.o.o. shall not be responsible for possible incorrect data caused by printing errors or error made in transcription and all figures and diagrams are for explanatory purposes only and relevant
adjustment have to be made at the spot. In any case, it reserves the right to modify its products as deemed to be required and useful without any prior notification.
Centrometal d.o.o. Glavna 12, 40306 Macinec, Croatia
central tel: +385 40 372 600, fax: +385 40 372 611
service tel: +385 40 372 622, fax: +385 40 372 621
www.centrometal.hr
e-mail: [email protected]
Operations to be performed by the Authorised
Service Centre every season before ignition.
• A general cleaning inside and outside.
• A careful cleaning of the exchange tubes.
• A careful cleaning and descaling of the crucible
and the corresponding compartment.
• Clean the motors, checking the play and
fastenings of the mechanisms.
• Clean the smoke channel (replace the gaskets
in the tubes) and smoke extractor fan
compartment.
• Clean pressure switch, replace the silicone tube.
• Check the sensor.
• Replace the batteries in the clock on the
electronic board.
• Clean, inspect and descale the ignition resistor
compartment, replacing it if necessary.
• Clean/check the display panel.
• Visually inspect the electrical cables, connections
and electric power cable.
• Clean the pellet container and check the play with
the screw feeder gear motor.
• Replace the door seals.
• Operational test, loading the screw feeder,
ignition, 10 minutes of operation and shut down.
• Check the electrical parts and the electronic
components.
• Check and possible cleaning of the channelling.
HEATING TECHNIQUE