Gamma X-6FC Instrukcja obsługi - Strona 10

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Maszyny naciągowe Gamma X-6FC. Gamma X-6FC 20 stron.
Również dla Gamma X-6FC: Instrukcja obsługi (20 strony)

Drukuj stronę

sion. The diamond coated gripper plates provide for increased friction between the clamps

and the string to allow for reduced clamping pressure while securing and holding the string

under tension.

Note: If the string slips in the string clamp while tensioning, adjust the gap between the

clamp jaws as per the instructions on page 15.

high tensions, additional tightness may be required.

STRINGING THE FRAME

String Clamp Operation

The ﬁ xed clamps are of a dual action de-

sign. The string clamp and the clamp base

operate independently of one another.

To clamp a string, lift the clamp head

and place the string between the jaws.

Depress the clamp head lever to secure

the string. The clamping pressure applied

to the string should be adjusted to provide

sufﬁ cient pressure to secure the string

when subjected to the desired pulling ten-

Base Clamp Operation

Rotate the lever lock clockwise to secure

the clamp base to the turntable.

Reverse the clamping procedure to unlock

the string clamp.

The lever should be tightened enough to

prevent clamp base slippage on the turn-

table, when the desired tension is placed

on the string. To go from the loose position

to the clamped position and back, gener-

ally requires about 1/2 to 3/4 quarters of a

turn. Although when stringing at extremely

Clamping the First Main String

To begin stringing the main strings, thread

the two ends of the string through the two

center holes at the appropriate end of the

frame and continue through the opposite

center holes. Thread one end of the string

through the adjacent grommet hole and

pull excess by hand.

Secure one of the strings using a string

clamp.