Decimator 12G-CROSS Instrukcja obsługi - Strona 13

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Konwerter mediów Decimator 12G-CROSS. Decimator 12G-CROSS 13 stron. Hdmi / sdi 4k cross converter with scaling and frame rate conversion

Drukuj stronę

Setting up Format Conversion

To setup the scaler module of the 12G-CROSS use the following steps:

Navigate to the control menu using the arrow buttons, press enter to go into it and The SDI OUTPUT SOURCE

should now be highlighted. Press the enter button to cycle from SDI IN to the Scaler. If you wish to output the

scaler on HDMI, press the right arrow once to reach the HDMI OUTPUT SOURCE and repeat the same step.

Control

SDI OUTPUT SOURCE

SDI IN

To now change the format you are converting to, press the back button once and then right arrow to reach the

Scaling menu. Press enter to go into it and the first option is the Output Format. By pressing enter and using

the arrow buttons you can navigate to the format you wish to convert to. The output will instantly update to

whichever format you have picked, provided a signal is present or free run is set.

Scaling

Output Format

6G 2160p59.94

Decimator Design warrants that this product will be free from defects in materials and workmanship for a period

of 36 months from the date of purchase. If this product proves to be defective within this warranty period,

Decimator Design, at its discretion, will either repair the defective product without charge for parts and labour,

or will provide a replacement product in exchange for the defective product.

In order to service under this warranty, you the Customer, must notify Decimator Design of the defect before

the expiration of the warranty period and make suitable arrangements for the performance of service. The

Customer shall be responsible for packaging and shipping the defective product to a designated service centre

nominated by Decimator Design, with shipping charges prepaid. Decimator Design shall pay for the return of

the product to the Customer if the shipment is to a location within the country in which the Decimator Design

service centre is located. The Customer shall be responsible for paying all shipping charges, insurance, duties,

taxes, and any other charges for products returned to any other location.

This warranty shall not apply to any defect, failure or damage caused by improper use or improper or inadequate

maintenance and care. Decimator Design shall not be obligated to furnish service under this warranty a) to

repair damage resulting from attempts by personnel other than Decimator Design representatives to install,

repair or service the product, b) to repair damage resulting from improper use or connection to incompatible

equipment, c) to repair any damage or malfunction caused by the use of non-Decimator Design parts or supplies,

or d) to service a product that has been modified or integrated with other products when the effect of such a

modification or integration increases the time of difficulty of servicing the product.

12G-CROSS OPERATING MANUAL VERSION 1.0

E&OE

SERVICE WARRANTY