Decimator MD-HX Instrukcja obsługi - Strona 10
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Konwerter mediów Decimator MD-HX. Decimator MD-HX 11 stron. Hdmi / (3g/hd/sd)-sdi cross converter with scaling and frame rate conversion
Również dla Decimator MD-HX: Instrukcja obsługi (11 strony)
- 1. Flow Chart
- 2. Main Menus
- 3. Input Status
- 4. Controls
- 5. Control/Hdmi out Type/Duc Source/Duc Ref/No Signal Back GD/3G Output Is B/Output 1 Is Loop
- 6. Scaling
- 7. Scaling/Output Format/Sd2Sd Aspect
- 8. Scaling/Hd2Sd Aspect/1080I/Horz Filter/Horizontal Flip/Vertical Flip
- 9. Audio
- 10. Setup/Load Defaults/Lcd off Time/Back2Status Time/Auto Save
- 11. Warranty
SERVICE WARRANTY
Decimator Design warrants that this product will be free from defects in materials and workmanship for a
period of 36 months from the date of purchase. If this product proves to be defective within this warranty
period, Decimator Design, at its discretion, will either repair the defective product without charge for parts and
labour, or will provide a replacement product in exchange for the defective product.
In order to service under this warranty, you the Customer, must notify Decimator Design of the defect before
the expiration of the warranty period and make suitable arrangements for the performance of service. The
Customer shall be responsible for packaging and shipping the defective product to a designated service centre
nominated by Decimator Design, with shipping charges prepaid. Decimator Design shall pay for the return of
the product to the Customer if the shipment is to a location within the country in which the Decimator Design
service centre is located. The Customer shall be responsible for paying all shipping charges, insurance, duties,
taxes, and any other charges for products returned to any other location.
This warranty shall not apply to any defect, failure or damage caused by improper use or improper or
inadequate maintenance and care. Decimator Design shall not be obligated to furnish service under this
warranty a) to repair damage resulting from attempts by personnel other than Decimator Design
representatives to install, repair or service the product, b) to repair damage resulting from improper use or
connection to incompatible equipment, c) to repair any damage or malfunction caused by the use of non‐
Decimator Design parts or supplies, or d) to service a product that has been modified or integrated with other
products when the effect of such a modification or integration increases the time of difficulty of servicing the
product.
9
MD‐HX OPERATING MANUAL VERSION 1.3
Copyright © 2015 Decimator Design Pty Ltd, Sydney, Australia
E&OE