Gamma Scale GMC-330 Instrukcja obsługi - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wagi Gamma Scale GMC-330. Gamma Scale GMC-330 6 stron. Digital counting scale

State B: Unit and weighing mode control character (D7 refers to verification bit)

D7 Verification bit

D6 0

D5 1

D4 1

D3 Dynamic mark bit

D2 Overload mark bit

D1 Positive and negative mark bit DIA, positive number: D1=1, negative number

DO, Gross weight and net weight mark bit DOA, gross weight; D0=1, net weight

State C: Blank space

5.1 Do not use under the environment of heavy dusty and high vibration.

5.2 Place the article in the center of the platter as far as possible.

5.3 Never use high corrosive solvents to clean it.

5.4 Do not weigh overload, weight (tare included) can't exceed its Max. Capacity

plus 9d ("d" is division value). If the weight exceeds this value, the indicator will

display as "FULL", and may possibly give out beep sound.

5.5 Do not place article on platter for a long period of time and never bump platter

in a sudden, otherwise, the load cell may be damaged.

5.6 Be sure that charging rechargeable battery in time if your scale has one.

5.7 Don't disassemble it without authorization.

5.8 If the display doesn't change during operation, turn off the switch of battery and

pull out the adaptor plug, then turn on the scale again.

5.9 If something is wrong, immediately turn off the switch of battery (or storage

battery) and pull out the adaptor plug. Non-professional staff can't fix it without

authorization. Contact our sales agent in local area.

5.10 To recalibrate the scale, do it after warmed up for 30minutes.

If using the rechargeable battery, please recharge it more often. Otherwise work

with attached adaptor.

D3--0, stability;

D2--O, normality; D2=1, overload

5. Use Guide

I -digit decimal

2-digit decimal

3-digit decimal

4-digit decimal 0.0000

D3=1, non-stability (dynamic)

- 5 -

0.0

0.00

0.000

<END>