Major tech MT767 Instrukcja obsługi - Strona 11

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Przyrządy pomiarowe Major tech MT767. Major tech MT767 12 stron. 600a ac/dc clamp meter with ir thermometer

Drukuj stronę

results, rub the probe tip along a length of the cord to assure placing the

tip in close proximity to the live conductor.

NOTE: The detector is designed with high sensitivity. Static electricity or

other sources of energy may randomly trip the sensor. This is

normal operation.

5.10. Mode/VFD Button

To select AC/DC A, Diode/Continuity/CAP,VAC/Hz/%, °C/ °F, In ACV mode,

hold down the mode key to enter VFD measurement mode and display

VFD. In VFD mode, low-pass filter can reduce the high-frequency noise

when measuring AC voltage. VFD mode is mainly used for AC voltage

measurement of variable frequency drive and frequency converter.

5.11. Data Hold/Flashlight Button

To freeze the LCD meter reading, press the data hold button. The data hold

button is located on the right side of the meter (top button). While data

hold is active, the HOLD display icon appears on the LCD. Press the data

hold button again to return to normal operation.

Hold down this button to turn the flashlight ON/OFF.

5.12. INRUSH/BLUETOOTH Button

In the AC current measurement mode, place a single power cord of the

motor in the center of the clamp, and press the "inrush/Bluetooth" key to

display "-". When the power is turned on, the surge current generated when

the motor is started can be measured and displayed on the LCD screen.

Press to exit the function. On a Smart Phone, the INRUSH/BLUETOOTH

button can be opened in any mode, and the Bluetooth connection mode will

be opened. The data of the corresponding function can be acquired through

the APP connection of mobile phone. (Meterbox Pro)

5.13. REL/

Button

Press REL key to enter the relative value measurement mode, take the

current value as the reference and obtain the relative value. Hold down this

key to turn on the laser in IR-temp measurement mode, and then press

this key to turn off the laser.

6. Battery Replacement

1. Remove the one rear head screw

2. Open the battery compartment

3. Replace the required three "AAA" 1.5V Batteries.

4. Re-assemble the meter