Decko 82004 Instrukcje montażu i pielęgnacji - Strona 2

Przeglądaj online lub pobierz pdf Instrukcje montażu i pielęgnacji dla Wyposażenie wnętrz Decko 82004. Decko 82004 2 stron. Adirondack chair

Drukuj stronę

ASSEMBLY TIPS

-Carefully read all of the steps and acquaint yourself with the

wood parts and fastener sizes before starting assembly.

-Separate fasteners by size before starting assembly

-During assembly all hardware should be semi tightened until the

final step

STEP 1

Lay seat assembly (B) flat on the

ground. Using two 4 x 40 mm wood

screws (M), attach the back assembly

(A) to the seat assembly. (NOTE:

There are no pre-drilled holes in the

seat assembly. The screws will self

thread into the wood).

STEP 2

Carefully lay the chair on its side as

shown. Using three 6 x 50 mm machine

screws (H) with flat washers (I) and nuts

(J) attach the right leg (E) to the seat

assembly. (The leg will be positioned

with the arm brace facing upward and to

the front of the seat assembly)

Using two 6 x 50 mm machine screws (H)

with flat washers (I) and nuts (J) attach

one back support (G) to the seat

assembly. Attach other end of back

support to back assembly using two 4 x

40 mm wood screws (M)

NOTE: Do not completely tighten all

fasteners at this time. Leave them a

bit loose until the final step.

STEP 3

Using two 4 x 40 mm wood screws (M)

attach the right arm (F) to the leg.

Attach the back of the arm to the back

assembly using one 5 x 60 mm wood

screw (K)

STEP 4

Turn chair onto its other side. Using

instructions from STEP 2 attach the

left leg (C) and back support (G) to the

seat and back assembly.

STEP 5

Using instructions from STEP 3 attach

the left arm (D) to the leg and back

support assembly

STEP 6

Completely tighten all fasteners and

enjoy your new chair.