Jalo Helsinki Kupu Podręcznik - Strona 2
Przeglądaj online lub pobierz pdf Podręcznik dla Alarm dymowy Jalo Helsinki Kupu. Jalo Helsinki Kupu 2 stron.
Drukuj stronę
INSTALLATION GUIDE
1
2
FAST INSTALLATION WITH 3M ADHESIVE TAPE
Please make sure your mounting surface is not too rough for the
adhesive tape. In such case use screws for installation.
1. Remove the other surface of the tape (A) .
Zull out the red tape sticking out of the base of the smoke alarm (B).
B
A
B
2. Press the smoke alarm against the ceiling vigorously for approximately
30 seconds (A). You can make slight adjustments to the alignment of the
smoke alarm by turning it to the wanted direction (B) .
B
A
3. Test your smoke alarm by pressing the cover down for at least
3 seconds (A). You should hear a couple chirps. Wait for 30 minutes and
make sure your installation is firm.
A
4. Installation is now complete!
Please remember to test your smoke alarm every week.
1 Whole surface test button
2 Indication led
3 Lithium batteries (3)
4 Red battery protection tape
5
6
3
4
INSTALLATION WITH SCREWS
1. Remove the mounting plate from the main unit by turning it
counterclockwise (A) and pulling it off (B).
2. Make markings for screw holes. (A)
You can align the smoke alarm with
the help of the alignment arrow (B).
It points to the same direction as the
sides of the smoke alarm.
B
3. Drill holes for the screw anchors and install the mounting plate
with screws and screw anchors.
5 Hush button
6 3M double-sided tape
7 Screws (2)
8 Screw anchors (2)
4. Pull out the red tape sticking out of the battery compartment (A).
Press the HUSH button (B).This allows you to press the front surface
of the smoke alarm without engaging the test alarm signal.
The HUSH function for the installation lasts for 90 seconds, before
returning to normal operating mode. While the installation HUSH
function is on, the smoke alarm gives a brief chirp every 30 seconds.
B
7
8
B
A
5. Press the smoke alarm against the mounting plate (A) and turn
the smoke alarm clockwise B until the smoke alarm and the mounting
plate make four clicks. NOTE: Mounting plate does not attach to the
main unit if batteries are not installed properly or are missing.
A
6. You can slightly adjust the alignment by turning the smoke alarm
towards the wanted direction (A).
7. After installation make sure that the smoke alarm is firmly attached
to the ceiling. Test your smoke alarm by pressing the cover down for
at least 3 seconds A. You should hear couple chirps.
8. Installation is now complete!
Please remember to test your smoke alarm every week.
A
A
B
A
A