Green Creative INNOFIT INFT9.5 Instrukcja instalacji - Strona 2

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Oprawa oświetleniowa Green Creative INNOFIT INFT9.5. Green Creative INNOFIT INFT9.5 2 stron.

Drukuj stronę
1.
Make sure the POWER IS TURNED OFF at the source to the
location in which you are installing the product.
2.
If using a new Construction Plate, install it in the ceiling following its
own installation instruction. (fig 1)
3.
If a new hole is needed, use a hole cutter, and set the diameter (see
detailled dimensions from the below table).
Attach the carabiner safety clip to a secure place inside the ceiling.
4.
Adjust the fixture power to desired lumen output by sliding the blue
5.
selector switch. Make sure the switch is never in between
positions.(fig. 4)
6.
Insert lamp conduit into a preinstalled J-box (not provided) and wire
to the power source (black to hot, white to neutral, green to ground).
For 0-10V dimming circuits, connect grey to grey and purple to
purple. Close the J-box securely. (fig. 5)
7.
Squeeze the two spring clips so they are in an upright position and
insert lamp into housing. (fig. 5)
Once lamp is inside the housing, release the spring clips and
8.
continue pushing fixture until securely fixed and flush with ceiling.
(fig. 6)
9.
Restore power at the source and the installation is complete.
Φ Inside Diameter
Φ Outside Trim Diameter
www.greencreative.com - [email protected] - Tel / Fax: (866) 774-5433 -
NEW CONSTRUCTION INSTALLATION
INNOFIT DOWNLIGHT HOUSING COMPATIBILITY
Fixture
Inside Diameter
INFT4
3-3/4"
INFT6
5-7/8"
INFT8
7-7/16"
INFT9.5
8-1/2"
INFT4
is compatible with most standard housing with aperture ranging from 3-7/8" to 5-1/8"
INFT6
is compatible with most standard housing with aperture ranging from 6" to 7-1/2"
INFT8
is compatible with most standard housing with aperture ranging from 7-9/16" to 9-7/16"
INFT9.5
is compatible with most standard housing with aperture ranging from 8-9/16" to 10-7/16"
/ GREENCREATIVELED
For Fixture Series: INFT4, INFT6, INFT8 and INFT9.5
NCPLATE
NCFJB
NCPLATE/T
Outside Trim Diameter
Fixture Height
5-15/16"
3-1/4"
8-1/4"
3-1/4"
10-1/4"
3-1/4"
11-1/4"
3-1/4"
/ GClightingLED
Minimum Cutout
Maximum Cutout
3-7/8"
6"
7-9/16"
8-9/16"
/ GREEN-CREATIVE
An ILLUMUS Brand
5-1/8"
7-1/2"
9-7/16"
10-7/16"