Green Digital Power-tech G60-12N Podręcznik użytkownika - Strona 2

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Ładowarka Green Digital Power-tech G60-12N. Green Digital Power-tech G60-12N 2 stron. 7.2v~12v nimh/nicd battery charger

Drukuj stronę

Brief Introduction

G60-12N is a main member of digital-chargers from Green Digital

Power-tech Co., Ltd. It represents today's new technology for 7.2V(6s) ~

12V(10s) NIMH/NICD battery pack charging. G60-12N programmed 3 auto

stages ( Ip-Im-It) charging process，It is designed for 6s(7.2V) ~ 10s(12V)

3~25Ah NIMH/NICD battery pack. Stage "Ip" is a pre-charge function for

deep discharged battery pack, this is helpful for battery's cycle life. When the

battery recovered by pre-charge small current, stage "Im" will give bulk current

charging. This is the main charge stage, when the battery nearly charged full ,

-dV phenomenon will be detected by the MCU in charger (-dV value is

3~6mV/per cell about) . Then the battery will leave bulk stage and cut-off

output or enter a defined trickle pulse charge stage "It" to maintain battery.

Further, G60 can display the charging process, indicate the battery

capacity from 25% to 100% timely. This is helpful for user.

For more safety, G60 will inter protection mode when the battery polarity

reversed our the output connectors shorted.

Specification for G60-12N

Input Voltage

100-240VAC，50-60Hz

Input Current

1.1A

Back current drain 1） <1mA

Charge voltage limit

16V

Pre-charge current

0.3A

Bulk charge current

G60-12NS

2.0A+-5%

Cutoff condition

-dV>=5mV/cell or Timer out or Peak-voltage trigger

Operate Temperature

-20℃~50℃

Natural convection. Do not cover the charger.

Cooling

Charge principle

Auto 3 stages: Ip-Im-It

Battery type

NIMH/NICD 7.2V~12V(6S~10S)

Battery capacity

3-25Ah

Size

120X67X41mm

Dust protected, Water splashing resistance)

Enclosure

IP54 (

Weight

270g

G60-12N

3.3A+-5%

Display Panel

Power on

(When

input OK)

How to use:

Connect the AC cord to the socket, The "power" lamp will light on solid.

indication light will indicate a battery which is connected to reverse polarity.

Connect positive charger clip (red) to positive battery terminal, the black clip

to negative. (You can use other dc plugs to connect battery), the

"25%~100%" lamps will light on flowing. If the battery polarity reversed or

output shorted, all lamps will flashing, please check the setup.

Depend on the charged capacity, 25%~100% lamps will lights up solid

sequence, the battery is fully charged. Then you can power off the charger

and disconnect the battery or you can charge a new battery if you need.

The table shows the duration of 95% state charged for an empty battery.

Battery Cap.（Ah）

G60-12N hours

3.6

8.0

12.0

25.0

Charging process indicator:

Indicate battery capacity from 25% to

100% when charging.

All lamps flashing means battery

polarity reversed or output shorted.

All lamps are "off" means no battery.

G60-12NS hours

1.5

4.5

8.5

Not recommend