ENGLISH
Accessories
• Wire shelf x 1
Before first use
Warning! Refer to Safety
chapters.
Initial Cleaning
Remove all accessories and removable shelf
supports from the appliance.
Refer to "Care and cleaning"
chapter.
Clean the appliance before first use.
Put the accessories and the removable shelf
supports back to their initial position.
Setting the time
After the first connection to the mains, all
symbols in the display are on for some
seconds. For the subsequent few seconds
the display shows the software version.
After the software version goes off, the
display shows
and "12:00". "12"
flashes.
1. Turn the knob for the temperature /
microwave power right or left to set the
current hour.
2. Press
to confirm. This is necessary
only when you set the time for the first
time. Later the new time will be saved
automatically after 5 seconds.
The display shows
"00" flashes.
3. Turn the knob for the temperature /
microwave power right or left to set the
current minutes
4. Press
to confirm. This is necessary
only when you set the time for the first
and the set hour.
For cookware, cake tins, roasts.
time. Later the new time will be saved
automatically after 5 seconds.
The display shows the new time.
Changing the time
You can change the time of day only when
the oven is in standby mode.
Press
again and again until the symbol
flashes in the display.
To set a new time, refer to "Setting the
time".
Using the Mechanical child lock
The appliance has the child lock installed
and activated. It is below the control panel
on the right side.
To open the oven door with the child lock
installed, pull the child lock handle up as
shown in the picture.
Close the oven door without pulling the
child lock.
To remove the child lock, open the oven
door and remove the child lock with the torx
key. The torx key is in the oven fitting bag.
Screw back the screw into the hole after
removing the child lock.
10
Drukuj stronę