IKEA Nutid Series Instrukcja instalacji - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Piekarnik IKEA Nutid Series. IKEA Nutid Series 24 stron. 24" (61.0 cm) or 30" (76.2 cm) built-in microwave oven
Również dla IKEA Nutid Series: Instrukcja obsługi i konserwacji (48 strony)

Drukuj stronę

Tools and Parts

Tools Needed

Gather the required tools and parts before starting installation.

Read and follow the instructions provided with any tools listed

here.

Measuring tape

■

Pencil

■

T10 TORX

screwdriver

®†

■

No. 3 square and/or No. 2 Phillips screwdriver

■

Drill

■

5/64" (2 mm) and 7/64" (3 mm) drill bits

■

1/4" (6 mm) shim*

■

* Shim may be needed for 30" (76.2 cm) installation in double-

walled cabinetry (having outer walls that protrude past the

front surface of the cutout opening). See Step 8 in the "Install

the Microwave Oven (30" [76.2 cm] Installation Only)" section.

Parts Supplied

All of the following parts are provided, but not all parts will be

used. The cutout opening size will determine which parts you will

use. See chart below parts list to see which parts are used for

each installation..

A. Side brackets (2)

B. Extension plates (2)

C. 3/8" (0.95 cm) T10 screws (4)

D. 1/2" (1.27 cm) T10 screws (4)

E. 1" (2.54 cm) T10 screws (4)

F. 1

" (3.81 cm) square/Phillips screws (2)

G. Mounting brackets (2)

H. Side trim panels (2)

I. Spacer strips (4)

INSTALLATION

24" (61.0 cm) installation

30" (76.2 cm) installation

†

TORX is a registered trademark of Acument Intellectual Properties, LLC

INSTALLATION REQUIREMENTS

PARTS USED

D, E, G, I

A, B, C, E, F, H, I

Location Requirements

The microwave oven may be located in a cabinet, and/or above

a built-in oven, or below the counter, and/or below a non-vented

cooktop. Check the opening where the microwave oven will be

installed. The location must provide:

Wood cabinetry.

■

Cutout opening that is plumb and square. See "Minimum

■

Cutout Dimensions" in the "Minimum Dimensions" section.

Cutout floor that is solid, level, and flush with bottom of

■

cabinet cutout.

Support for weight of at least 150 lbs (68 kg), which includes

■

microwave oven and items placed inside.

Grounded electrical outlet. See the "Electrical Requirements"

■

section.

Minimum installation clearances for installation location.

■

See the "Minimum Dimensions" section.

Complete enclosure around the recessed portion of the

■

microwave oven.