IKEA Oven Podręcznik użytkownika - Strona 6

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Piekarnik IKEA Oven. IKEA Oven 8 stron. Oven built in
Również dla IKEA Oven: Podręcznik użytkownika (7 strony)

Drukuj stronę

61901363GB.fm Page 16 Tuesday, January 1, 2002 3:20 AM

MAINTENANCE

Care and maintenance

Clean the hob after each use in order to avoid damaging

the surface and to prevent the formation of baked-on

deposits which are difficult to remove. Before cleaning,

make sure the cooking zones are switched off and that

the residual heat indicator ("H") is not displayed.

• Steam cleaner is not to be used!

• Periodically check for dust under the appliance,

near the cooling air inlet or the outlet openings.

This could hinder the ventilation and cooling

of the electronic module and decrease the

effectiveness of the hob.

Troubleshooting Guide

• Before contacting After-sales Service:

• read and follow the instructions given in the section

"Operating instructions".

• Connect the hob to the electricity supply and check that

the supply has not been shut off.

ERROR CODE

The hob switches off

and after 30 seconds

Continuous pressure on

emits an acoustic signal

every 4 seconds

The control panel switches off

C81, C82

because of excessively high

The connection voltage is

F40

F25, F36, F40, F45,

F47, F54, F56, F60, F70

Important!

If you are unable to turn the glass-ceramic hob off after using it, disconnect it immediately from the

power supply.

After-sales Service

Before contacting After-sales Service:

• Try to eliminate the problem (consult "Troubleshooting

Guide").

• Switch the appliance off, wait 30 seconds then switch it

on again. to see if the fault persists.

If after the above checks the fault persists, contact the

nearest After-sales Service.

To clean the hob, proceed as follows:

1. use a soft clean cloth, absorbent kitchen wipes or a

2. Food spills should be cleaned off before they bake

3. Remove any stubborn food residues with a scraper or

4. Salt, sugar and sand can scratch the glass ceramic hob:

• Clean the hob and dry it thoroughly.

• If, when the hob is switched on, alphanumeric codes

DESCRIPTION

POSSIBLE CAUSES

Water or utensils on control panel

control panel area

The internal temperature of

electronic parts is too high

temperatures

The sensor detects a discrepancy

between the appliance voltage and

wrong

that of the mains supply

Call the After-Sales Service and specify the error code

Always provide:

• a brief description of the fault;

• the exact type and model;

• the service number (number after the word Service on

• your complete address and phone number.

If any repairs are required, please contact an authorized

After-sales Service as indicated in the warranty.

proprietary cleaner for glass ceramic hobs. Do not use

abrasive sponges and/or metal scouring pads.

onto the glass ceramic surface. Sugar and foods with a

high sugar content damage the glass ceramic surface

and must be immediately removed using a scraper for

glass. Caution! Glass scrapers have a very sharp blade

and must be handled with care.

proprietary detergents.

clean up any such spills on the hob immediately.

appear on the display, consult the following table for

instructions.

Clean the control panel

Wait for the hob to cool down

before using it again

Disconnect the hob from the

mains and check the electrical

the dataplate), located under the hob or in the warranty

booklet;

REMEDY

connection