IKEA 404.947.78 Podręcznik - Strona 6
Przeglądaj online lub pobierz pdf Podręcznik dla Lodówka IKEA 404.947.78. IKEA 404.947.78 41 stron.
Drukuj stronę
ENGLISH
Installation
The appliance must be handled and
installed by two or more persons - risk of
injury. Use protective gloves to unpack and
install - risk of cuts.
Installation, including water supply (if
any) and electrical connections, and repairs
must be carried out by a qualified technician.
Follow the installation instructions supplied
with the appliance. Remove all the
packaging and make sure that it has not
been damaged during transport. In the
event of problems, contact the dealer or
your nearest Authorised Service Centre. Do
not install or use a damaged appliance.
Do not use the appliance before
installing it in the built-in structure.
Install the appliance in a safe and
suitable place that meets installation
requirements. Ensure that the appliance is
switched off and disconnected from the
power supply before performing any
Electrical warnings
Make sure that the parameters on the
rating plate are compatible with the
electrical ratings of the mains power supply.
Do not use extension leads, multiple
sockets or adapters. The appliance must be
earthed. Always use a correctly installed
shockproof socket. The electrical
components must not be accessible to the
user after installation. The mains cable must
stay below the level of the mains plug. Do
not operate this appliance if it has a
damaged power cable or plug, if it is not
working properly, or if it has been damaged
or dropped.
Make sure not to cause damage to the
electrical components (e.g. mains plug,
mains cable, compressor). Contact the
Authorised Service Centre or an electrician
to change the electrical components.
To download the full version visit www.ikea.com
maintenance operation - risk of electric
shock. Only activate the appliance when the
installation has been completed.
Carry out all cabinet cutting works before
fitting the appliance in the furniture and
remove all wood chips and sawdust. Make
sure the air ventilation around the appliance.
Do not install the appliance close to
radiators or cookers, ovens or hobs. Do not
expose the appliance to the rain. Do not
install the appliance where there is direct
sunlight. Do not install this appliance in
areas that are too humid or too cold.
At first installation or after reversing the
door wait at least 4 hours before connecting
the appliance to the power supply. This is to
allow the oil to flow back in the compressor.
When you move the appliance, lift it by
the front edge to avoid scratching the floor.
Connect the mains plug to the mains
socket only at the end of the installation.
Make sure that there is access to the mains
plug after the installation. Do not pull the
mains cable to disconnect the appliance.
Always pull the mains plug.
To replace the power cable or the
internal lighting, contact the Authorized
Service Centre.
This product contains a light source of
energy efficiency class G.
Concerning the lamp(s) inside this
product and spare part lamps sold
separately: These lamps are intended to
withstand extreme physical conditions in
household appliances, such as temperature,
vibration, humidity, or are intended to signal
6